검색결과 : 53건
| No. | Article |
|---|---|
| 1 |
Foaming parameter identification of polyurethane using FOAMAT (R) device Raimbault C, Laure P, Francois G, Boyer S, Vincent M, Choquart F, Agassant JF Polymer Engineering and Science, 61(4), 1243, 2021 |
| 2 |
Special issue for Pierre J. Carreau Agassant JF, Lafleur P International Polymer Processing, 35(5), 414, 2020 |
| 3 |
Abnormal Behaviors in the Capillary Rheometry of Plastisol Formulations Demay Y, Abdesselam Y, Castellani R, Agassant JF International Polymer Processing, 33(3), 363, 2018 |
| 4 |
Modelling of the Plastisol Knife Over Roll Coating Process Abdesselam Y, Demay Y, Castellani R, Agassant JF, Peres R, Gourdin D International Polymer Processing, 32(5), 555, 2017 |
| 5 |
Rheology of plastisol formulations for coating applications Abdesselam Y, Agassant JF, Castellani R, Valette R, Demay Y, Gourdin D, Peres R Polymer Engineering and Science, 57(9), 982, 2017 |
| 6 |
Numerical Modeling of Bubble Growth in Microcellular Polypropylene Produced in a Core-Back Injection Process Using Chemical Blowing Agents Ruiz JAR, Vincent M, Agassant JF International Polymer Processing, 31(1), 26, 2016 |
| 7 |
Experimental Investigation and Modeling of a New High Speed Coating Process Kallel M, Demay Y, Agassant JF, Chartrel JF, Grisot M International Polymer Processing, 31(3), 369, 2016 |
| 8 |
A Personal Perspective on the Use of Modelling Simulation for Polymer Melt Processing Agassant JF, Mackley MR International Polymer Processing, 30(1), 121, 2015 |
| 9 |
Polymer foaming with chemical blowing agents: Experiment and modeling Ruiz JAR, Vincent M, Agassant JF, Sadik T, Pillon C, Carrot C Polymer Engineering and Science, 55(9), 2018, 2015 |
| 10 |
Morphological analysis of microcellular PP produced in a core-back injection process using chemical blowing agents and gas counter pressure Ruiz JAR, Vincent M, Agassant JF, Claverie A, Huck S Polymer Engineering and Science, 55(11), 2465, 2015 |