화학공학소재연구정보센터
검색결과 : 10건
No. Article
1 Numerical study of turbulent flow past a rotating axial-flow pump based on a level-set immersed boundary method
Kan K, Yang ZX, Lyu P, Zheng Y, Shen L
Renewable Energy, 168, 960, 2021
2 Numerical investigation and experiment on pressure pulsation characteristics in a full tubular pump
Shi LJ, Yuan Y, Jiao HF, Tang FP, Cheng L, Yang F, Jin Y, Zhu J
Renewable Energy, 163, 987, 2021
3 Experimental and numerical investigation on the effect of tip leakage vortex induced cavitating flow on pressure fluctuation in an axial flow pump
Shen X, Zhang DS, Xu B, Shi WD, van Esch BPM
Renewable Energy, 163, 1195, 2021
4 Numerical simulation and experimental study of transient characteristics in an axial flow pump during start-up
Fu SF, Zheng Y, Kan K, Chen HX, Han XX, Liang XL, Liu HW, Tian XQ
Renewable Energy, 146, 1879, 2020
5 Experimental investigation of floor-attached vortex effects on the pressure pulsation at the bottom of the axial flow pump sump
Song XJ, Liu C
Renewable Energy, 145, 2327, 2020
6 Numerical simulation and experimental study on the comparison of the hydraulic characteristics of an axial-flow pump and a full tubular pump
Shi LJ, Zhang WP, Jiao HF, Tang FP, Wang L, Sun DD, Shi W
Renewable Energy, 153, 1455, 2020
7 Study on improvement of hydraulic performance and internal flow pattern of the axial flow pump by groove flow control technology
Mu T, Zhang R, Xu H, Zheng Y, Fei ZD, Li JH
Renewable Energy, 160, 756, 2020
8 Installation of an axial Pump-as-Turbine (PaT) in a wastewater sewer of an oil refinery: A case study
Renzi M, Rudolf P, Stefan D, Nigro A, Rossi M
Applied Energy, 250, 665, 2019
9 Numerical analysis of unsteady tip leakage vortex cavitation cloud and unstable suction-side-perpendicular cavitating vortices in an axial flow pump
Zhang DS, Shi L, Shi WD, Zhao RJ, Wang HY, van Esch BPM
International Journal of Multiphase Flow, 77, 244, 2015
10 Numerical simulation of liquid-solid two-phase flow in a tubular loop polymerization reactor
Shi DP, Luo ZH, Zheng ZW
Powder Technology, 198(1), 135, 2010