| 1 |
Particle swarm optimization-based algorithms for solving inverse problems of designing thermal cloaking and shielding devices
Alekseev GV, Tereshko DA
International Journal of Heat and Mass Transfer, 135, 1269, 2019 |
| 2 |
The design of optimum perforation diameters for pin fin array for heat transfer enhancement
Huang CH, Liu YC, Ay H
International Journal of Heat and Mass Transfer, 84, 752, 2015 |
| 3 |
An impingement heat sink module design problem in determining simultaneously the optimal non-uniform fin widths and heights
Huang CH, Chen YH
International Journal of Heat and Mass Transfer, 73, 627, 2014 |
| 4 |
The design of uniform tube flow rates for Z-type compact parallel flow heat exchangers
Huang CH, Wang CH
International Journal of Heat and Mass Transfer, 57(2), 608, 2013 |
| 5 |
The study on the improvement of system uniformity flow rate for U-type compact heat exchangers
Huang CH, Wang CH
International Journal of Heat and Mass Transfer, 63, 1, 2013 |
| 6 |
An impingement heat sink module design problem in determining optimal non-uniform fin widths
Huang CH, Chen YH, Li HY
International Journal of Heat and Mass Transfer, 67, 992, 2013 |
| 7 |
An inverse geometry design problem in optimizing the shape of the gas channel for a proton exchange membrane fuel cell
Huang CH, Chen LY, Kim S
Journal of Power Sources, 187(1), 136, 2009 |
| 8 |
Optimization of block layout design problems with unequal areas: A comparison of MILP and MINLP optimization methods
Castillo I, Westerlund J, Emet S, Westerlund T
Computers & Chemical Engineering, 30(1), 54, 2005 |
