검색결과 : 3건
| No. | Article |
|---|---|
| 1 |
Material flow influence on the quality of molded parts Solomon N, Solomon I, Sanduleac E Polymer Bulletin, 76(11), 5981, 2019 |
| 2 |
Rheological Properties of Elastomer-Modified Polypropylene and Their Influence on the Formation of Flow Marks Iannuzzi G, Rigdahl M Journal of Applied Polymer Science, 118(1), 604, 2010 |
| 3 |
Experimental study of the transcription of minute width grooves by injection molding (II) Yoshii M, Kuramoto H, Ochiai Y Polymer Engineering and Science, 38(9), 1587, 1998 |