| 1 |
Enhanced impact strength of injection-compression molded parts by controlling residual stress distribution
Oh HJ, Song YS
Korea-Australia Rheology Journal, 31(1), 35, 2019 |
| 2 |
Simulation of injection-compression molding for thin and large battery housing
Kwon YI, Lim E, Song YS
Current Applied Physics, 18(11), 1451, 2018 |
| 3 |
Application of injection-compression molding to thin-walled polymeric parts
Kwon YI, Song YS
Korea-Australia Rheology Journal, 30(3), 161, 2018 |
| 4 |
Comparison of injection molding and injection/compression molding for the replication of microstructure
Hong S, Hwang J, Kang J, Yoon K
Korea-Australia Rheology Journal, 27(4), 309, 2015 |
| 5 |
다수 개 빼기 성형에서 일반사출성형과 사출압축성형의 성형특성 비교
이단비, 남윤효, 류민영
Polymer(Korea), 38(2), 144, 2014 |
| 6 |
사출압축성형에서 복굴절을 통한 성형조건에 따른 성형특성 고찰
이단비, 남윤효, 류민영
Polymer(Korea), 38(2), 193, 2014 |
| 7 |
Injection Molding and Injection Compression Molding of Thin-Walled Light-Guided Plates with V-Grooved Microfeatures
Huang MS, Chung CF
Journal of Applied Polymer Science, 121(2), 1151, 2011 |
| 8 |
Study on optical properties of microstructure of lightguiding plate for micro injection molding and micro injection-compression molding
Shen YK, Chang HJ, Lin CT
Materials Science Forum, 505-507, 229, 2006 |
