| 1 |
Preparation of alumina-toughened zirconia via 3D printing and liquid precursor infiltration: manipulation of the microstructure, the mechanical properties and the low temperature aging behavior
Wu HD, Liu W, Lin LF, Li L, Li YH, Tian Z, Zhao Z, Ji XR, Xie ZP, Wu SH
Journal of Materials Science, 54(10), 7447, 2019 |
| 2 |
Fabrication of high-performance Al2O3-ZrO2 composite by a novel approach that integrates stereolithography-based 3D printing and liquid precursor infiltration
Wu HD, Liu W, Huang RJ, He RX, Huang MP, An D, Li HZ, Jiang QG, Tian Z, Ji XR, Xie ZP, Wu SH
Materials Chemistry and Physics, 209, 31, 2018 |
| 3 |
Research into the mechanical properties, sintering mechanism and microstructure evolution of Al2O3-ZO(2) composites fabricated by a stereolithography-based 3D printing method
Wu ZW, Liu W, Wu HD, Huang RJ, He RX, Jiang QG, Chen Y, Ji XR, Tian Z, Wu SH
Materials Chemistry and Physics, 207, 1, 2018 |
| 4 |
Facile synthesis and characterization of hexagonal NbSe2 nanoplates
Zhang XH, Zhang D, Tang H, Ji XR, Zhang Y, Tang GG, Li CS
Materials Research Bulletin, 53, 96, 2014 |
