검색결과 : 9건
| No. | Article |
|---|---|
| 1 |
Microstructure evolution of 316L stainless steel micro components prepared by micro powder injection molding Liu L, Loh NH, Tay BY, Tor SB Powder Technology, 206(3), 246, 2011 |
| 2 |
Optimization of Compression Molding of Stand-Alone Microlenses: Simulation and Experimental Results Mirkhalaf M, Tor SB, Murukeshan VM, Loh NH, Lye SW Polymer Engineering and Science, 50(11), 2216, 2010 |
| 3 |
Characterisation of micro gears produced by micro powder injection moulding Tay B, Loh NH, Tor SB, Ng FL, Fu G, Lu XH Powder Technology, 188(3), 179, 2009 |
| 4 |
Processing of biocomposite Ti-6Al-4V/HA powder Thian ES, Loh NH, Khor KA, Tor SB Journal of Materials Science Letters, 22(10), 775, 2003 |
| 5 |
Micro powder injection molding of metal microstructures Loh NH, Tor SB, Tay BY, Murakoshi Y, Maeda R Materials Science Forum, 426-4, 4289, 2003 |
| 6 |
Effects of debinding parameters on powder injection molded Ti-6Al-4V/HA composite parts Thian ES, Loh NH, Khor KA, Tor SB Advanced Powder Technology, 12(3), 361, 2001 |
| 7 |
Production of micro components by micro powder injection molding Liu ZY, Loh NH, Tor SB, Khor KA, Murakoshi Y, Maeda R Journal of Materials Science Letters, 20(4), 307, 2001 |
| 8 |
X-Ray-Imaging of Metal Injection-Molding Parts Fu YQ, Ji CH, Batchelor AW, Loh NH Journal of Materials Science Letters, 16(22), 1873, 1997 |
| 9 |
Yield Stress Behavior of Metal Injection-Molding Suspensions at Elevated-Temperatures Foong ML, Tam KC, Loh NH Journal of Materials Science, 30(14), 3625, 1995 |