| 1 |
A novel PEG/PMMA based binder composition for void-free metal injection moulding of Ti components
Hayat MD, Zhang HZ, Karumbaiah KM, Singh H, Xu Y, Zou LM, Qu XH, Ray S, Cao P
Powder Technology, 382, 431, 2021 |
| 2 |
Fabrication of titanium components by low-pressure powder injection moulding using hydride-dehydride titanium powder
Moghadam MS, Fayyaz A, Ardestani M
Powder Technology, 377, 70, 2021 |
| 3 |
Metal injection moulding of surgical tools, biomaterials and medical devices: A review
Dehghan-Manshadi A, Yu P, Dargusch M, StJohn D, Qian M
Powder Technology, 364, 189, 2020 |
| 4 |
Experimental and numerical analysis of effects of supercritical carbon dioxide debinding on Inconel 718 MIM components
Olivier D, Aboubabky A, Antonia JM, Manuel TJ, Thierry B
Powder Technology, 355, 57, 2019 |
| 5 |
Cyclic voltammetry study of PEO processing of porous Ti and resulting coatings
Shbeh M, Yerokhin A, Goodall R
Applied Surface Science, 439, 801, 2018 |
| 6 |
Improving titanium injection moulding feedstock based on PEG/PPC based binder system
Hayat MD, Jadhav PP, Zhang HZ, Ray S, Cao P
Powder Technology, 330, 304, 2018 |
| 7 |
Effects of oxygen contents on sintering mechanism and sintering-neck growth behaviour of Fe-Cr powder
He H, Lou J, Li YM, Zhang H, Yuan S, Zhang Y, Wei XS
Powder Technology, 329, 12, 2018 |
| 8 |
Capillary rheological studies of 17-4 PH MIM feedstocks prepared using a custom CSIR binder system
Machaka R, Ndlangamandla P, Seerane M
Powder Technology, 326, 37, 2018 |
| 9 |
Aqueous debinding of polyvinyl butyral based binder system for titanium metal injection moulding
Thavanayagam G, Swan JE
Powder Technology, 326, 402, 2018 |
| 10 |
Influence of supercritical debinding and processing parameters on final properties of injection-moulded Inconel 718
Royer A, Barriere T, Bienvenu Y
Powder Technology, 336, 311, 2018 |
