| 1 |
Impact of binder constituents on the moldability of titanium-based feedstocks used in low-pressure powder injection molding
Cote R, Azzouni M, Demers V
Powder Technology, 381, 255, 2021 |
| 2 |
Numerical simulation and experimental investigation of mold filling and segregation in low-pressure powder injection molding of metallic feedstock
Ben Trad MA, Demers V, Cote R, Sardarian M, Dufresne L
Advanced Powder Technology, 31(3), 1349, 2020 |
| 3 |
Numerical analysis of the effect of the local variation of viscosity on bubble growth and deformation in polymer foaming
Ataei M, Shaayegan V, Wang CD, Costa F, Han SJ, Park CB, Bussmann M
Journal of Rheology, 63(6), 895, 2019 |
| 4 |
Numerical simulation of mold filling process for high chromium cast iron matrix composite reinforced by ZTA ceramic particles
Du J, Chong XY, Jiang YH, Feng J
International Journal of Heat and Mass Transfer, 89, 872, 2015 |
| 5 |
Imbalance filling of multi-cavity tooling during powder injection molding
Kim J, Ahn S, Atre SV, Park SJ, Kang TG, German RM
Powder Technology, 257, 124, 2014 |
| 6 |
Numerical simulation of reactive flow in liquid composite molding using flux-corrected transport (FCT) based finite element/control volume (FE/CV) method
Tan H, Pillai KM
International Journal of Heat and Mass Transfer, 53(9-10), 2256, 2010 |
| 7 |
Modeling and simulation of the viscoelastic fluid mold filling process by level set method
Yang BX, Ouyang J, Li QA, Zhao ZF, Liu CT
Journal of Non-Newtonian Fluid Mechanics, 165(19-20), 1275, 2010 |
| 8 |
Numerical Simulation of Mold Filling Processes with Polyurethane Foams
Geier S, Winkler C, Piesche M
Chemical Engineering & Technology, 32(9), 1436, 2009 |
| 9 |
Three-Dimensional Flow Simulation of Resin Transfer Molding Utilizing Multilayered Fiber Preform
Lee SH, Yang M, Song YS, Kim SY, Youn JR
Journal of Applied Polymer Science, 114(3), 1803, 2009 |
| 10 |
Direct simulations on 2D mold-filling processes of particle-filled fluids
Hwang WR, Kim WY, Kang SH, Kim SJ
Korea-Australia Rheology Journal, 21(3), 193, 2009 |
