검색결과 : 11건
| No. | Article |
|---|---|
| 1 |
Use of a fiber optic distributed temperature sensing system for thermal response testing of ground-coupled heat exchangers Herrera C, Nellis G, Reindl D, Klein S, Tinjum JM, McDaniel A Geothermics, 71, 331, 2018 |
| 2 |
Measured and predicted heat transfer coefficients for boiling zeotropic mixed refrigerants in horizontal tubes Barraza R, Nellis G, Klein S, Reindl D International Journal of Heat and Mass Transfer, 97, 683, 2016 |
| 3 |
Measured and predicted frictional pressure drop for boiling zeotropic mixed refrigerants in horizontal tubes Barraza R, Nellis G, Klein S, Reindl D International Journal of Heat and Mass Transfer, 98, 285, 2016 |
| 4 |
Effect of resist surface characteristics on film-pulling velocity in immersion lithography Schuetter S, Shedd T, Nellis G, Romano A, Dammel R, Padmanaban M, Houlihan F, Krawicz A, Lin G, Rahman D, Chakrapani S, Neisser M, Van Peski C Journal of Vacuum Science & Technology B, 24(6), 2798, 2006 |
| 5 |
Full wafer simulation of immersion fluid heating El-Morsi M, Nellis G, Schuetter S, Van Peski C, Grenville A Journal of Vacuum Science & Technology B, 23(6), 2596, 2005 |
| 6 |
Control of the receding meniscus in immersion lithography Burnett H, Shedd T, Nellis G, El-Morsi M, Engelstad R, Garoff S, Varanasi K Journal of Vacuum Science & Technology B, 23(6), 2611, 2005 |
| 7 |
Static and dynamic contact angles of water on photoresist Burnett H, Shedd T, Nellis G, Van Peski C Journal of Vacuum Science & Technology B, 23(6), 2721, 2005 |
| 8 |
Predicting the fluid behavior during the dispensing process for step-and-flash imprint lithography Abdo A, Schuetter S, Nellis G, Wei A, Engelstad R, Truskett V Journal of Vacuum Science & Technology B, 22(6), 3279, 2004 |
| 9 |
Predicting air entrainment due to topography during the filling and scanning process for immersion lithography Wei A, El-Morsi M, Nellis G, Abdo A, Engelstad R Journal of Vacuum Science & Technology B, 22(6), 3444, 2004 |
| 10 |
Optimizing the fluid dispensing process for immersion lithography Abdo A, Nellis G, Wei A, El-Morsi M, Engelstad R, Brueck SRJ, Neumann A Journal of Vacuum Science & Technology B, 22(6), 3454, 2004 |