| 1 |
Experimental and CFD analyses of corrugated-plate solar collector by force convection
Pathak PK, Chandra P, Raj G
Energy Sources Part A-recovery Utilization and Environmental Effects, 42(3), 304, 2020 |
| 2 |
Turbine and exhaust ports thermal insulation impact on the engine efficiency and aftertreatment inlet temperature
Lujan JM, Serrano JR, Piqueras P, Diesel B
Applied Energy, 240, 409, 2019 |
| 3 |
Low temperature, medium temperature and high temperature performance of the continuous regenerative diesel particulate filter assisted by electric regeneration
Zhong C, Gong JK, Liu WN, Liu GL
Chemical Engineering Science, 207, 980, 2019 |
| 4 |
Semiempirical thermodynamic modeling of a direct methanol fuel cell system
Ince AC, Karaoglan MU, Glusen A, Colpan CO, Muller M, Stolten D
International Journal of Energy Research, 43(8), 3601, 2019 |
| 5 |
The thermal characteristics and performance of a ground heat exchanger for tropical climates
Yusof TM, Ibrahim H, Azmi WH, Rejab MRM
Renewable Energy, 121, 528, 2018 |
| 6 |
Design and performance analysis of a mixed mode tent-type solar dryer for fish-drying in coastal areas
Mehta P, Samaddar S, Patel P, Markam B, Maiti S
Solar Energy, 170, 671, 2018 |
| 7 |
CFD and experimental investigation of flat plate solar water heating system under steady state condition
Gunjo DG, Mahanta P, Robi PS
Renewable Energy, 106, 24, 2017 |
| 8 |
Study on co-cracking performance of different hydrocarbon mixture in a steam pyrolysis furnace
Yuan BF, Li JL, Du WL, Qian F
Chinese Journal of Chemical Engineering, 24(9), 1252, 2016 |
| 9 |
Applicability of the pipe structure and flow velocity of vertical ground heat exchanger for ground source heat pump
Zhou H, Lv J, Li TL
Energy and Buildings, 117, 109, 2016 |
| 10 |
Outlet Temperature Correlation and Prediction of Transfer Line Exchanger in an Industrial Steam Ethylene Cracking Process
Jin YK, Li JL, Du WL, Wang ZL, Qian F
Chinese Journal of Chemical Engineering, 21(4), 388, 2013 |
