| 1 |
Injection moulding of porous MAX phase Ti3SiC2 without using space-holder
Tabares E, Cifuentes SC, Jimenez-Morales A, Tsipas SA
Powder Technology, 380, 96, 2021 |
| 2 |
Fabrication of titanium components by low-pressure powder injection moulding using hydride-dehydride titanium powder
Moghadam MS, Fayyaz A, Ardestani M
Powder Technology, 377, 70, 2021 |
| 3 |
Optimizing hydride-dehydride Ti-6Al-4V feedstock composition for titanium powder injection moulding
Thavanayagam G, Swan JE
Powder Technology, 355, 688, 2019 |
| 4 |
Powder distribution on powder injection moulding of ceramic green compacts using thermogravimetric analysis and differential scanning calorimetry
Poh L, Della C, Ying SJ, Goh C, Li Y
Powder Technology, 328, 256, 2018 |
| 5 |
Microstructure and physical and mechanical properties of micro cemented carbide injection moulded components
Fayyaz A, Muhamad N, Sulong A
Powder Technology, 326, 151, 2018 |
| 6 |
Development of feedstocks based on steel matrix composites for metal injection moulding
Romero A, Herranz G
Powder Technology, 308, 472, 2017 |
| 7 |
Influence of particle-size distribution and temperature on the rheological properties of highly concentrated Inconel feedstock alloy 718
Dimitri C, Mohamed S, Thierry B, Jean-Claude G
Powder Technology, 322, 273, 2017 |
| 8 |
Prediction of density variation in powder injection moulding-filling process by using granular modelling with interstitial power-law fluid
He H, Li YM, Lou J, Li DP, Liu C
Powder Technology, 291, 52, 2016 |
| 9 |
Analysis of rheological behaviour of titanium feedstocks formulated with a water-soluble binder system for powder injection moulding
Thavanayagam G, Pickering KL, Swan JE, Cao P
Powder Technology, 269, 227, 2015 |
| 10 |
Capillary rheology studies of INVAR 36 feedstocks for powder injection moulding
Hidalgo J, Jimenez-Morales A, Barriere T, Gelin JC, Torralba JM
Powder Technology, 273, 1, 2015 |
