| 1 |
EDeSSOpt - Energy Demand and Supply Simultaneous Optimization for cost-optimized design: Application to a multi-family building
Ferrara M, Rolfo A, Prunotto F, Fabrizio E
Applied Energy, 236, 1231, 2019 |
| 2 |
Chemically stabilised extruded and recast short side chain Aquivion (R) proton exchange membranes for high current density operation in water electrolysis
Siracusano S, Oldani C, Navarra MA, Tonella S, Mazzapioda L, Briguglio N, Arico AS
Journal of Membrane Science, 578, 136, 2019 |
| 3 |
Tools and procedures to support decision making for cost-effective energy and carbon emissions optimization in building renovation
Dalla Mora T, Peron F, Romagnoni P, Almeida M, Ferreira M
Energy and Buildings, 167, 200, 2018 |
| 4 |
The performance of small scale multi-generation technologies in achieving cost-optimal and zero-energy office building solutions
Mohamed A, Hamdy M, Hasan A, Siren K
Applied Energy, 152, 94, 2015 |
| 5 |
Cost-optimal design for nearly zero energy office buildings located in warm climates
Congedo PM, Baglivo C, D'Agostino D, Zaca I
Energy, 91, 967, 2015 |
| 6 |
Cost optimality assessment of a single family house: Building and technical systems solutions for the nZEB target
Becchio C, Dabbene P, Fabrizio E, Monetti V, Filippi M
Energy and Buildings, 90, 173, 2015 |
| 7 |
Research of the recast layer on implant surface modified by micro-current electrical discharge machining using deionized water mixed with titanium powder as dielectric solvent
Chen SL, Lin MH, Huang GX, Wang CC
Applied Surface Science, 311, 47, 2014 |
| 8 |
A simulation-based optimization method for cost-optimal analysis of nearly Zero Energy Buildings
Ferrara M, Fabrizio E, Virgone J, Filippi M
Energy and Buildings, 84, 442, 2014 |
| 9 |
Fabrication of micro-pin array with high aspect ratio on stainless steel using nanosecond laser beam machining
Lee SW, Shin HS, Chu CN
Applied Surface Science, 264, 653, 2013 |
| 10 |
Numerical prediction of heat affected layer in the EDM of aeronautical alloys
Izquierdo B, Plaza S, Sanchez JA, Pombo I, Ortega N
Applied Surface Science, 259, 780, 2012 |
