| 1 |
Developing a method to design and simulation of a very low head axial turbine with adjustable rotor blades
Haghighi MHS, Mirghavarni SM, Chini SF, Riasi A
Renewable Energy, 135, 266, 2019 |
| 2 |
Turbines for modular tidal current energy converters
Kaufmann N, Carolus T, Starzmann R
Renewable Energy, 142, 451, 2019 |
| 3 |
Study of the wet steam flow in the blade tip rotor linear blade cascade
Dykas S, Majkut M, Smolka K, Strozik M
International Journal of Heat and Mass Transfer, 120, 9, 2018 |
| 4 |
Heat transfer in a two-inlet rotating rectangular channel with side-wall fluid extraction
Deng HW, Chen YN, Tao Z, Li Y, Qiu L
International Journal of Heat and Mass Transfer, 105, 525, 2017 |
| 5 |
Optimization of Rotor Geometry for a Type of Self-Suction Aerating Mechanical Flotation Cell
Yang T, Peng LZ, Liu TY, Wang B, Han LH, Liu Q
Journal of Chemical Engineering of Japan, 49(4), 332, 2016 |
| 6 |
The effect of delaminations on local buckling in wind turbine blades
Haselbach PU, Bitsche RD, Branner K
Renewable Energy, 85, 295, 2016 |
| 7 |
Endwall thermal performances of radially rotating rectangular channel with pin-fins on skewed rib lands
Chang SW, Hu YW
International Journal of Heat and Mass Transfer, 69, 173, 2014 |
| 8 |
Predicting wind turbine blade loads and aeroelastic response using a coupled CFD-CSD method
Yu DO, Kwon OJ
Renewable Energy, 70, 184, 2014 |
| 9 |
Multi-point aerodynamic optimization of the rotor blade sections of an axial-flow impulse air turbine for wave energy conversion
Gomes RPF, Henriques JCC, Gato LMC, Falcao AFO
Energy, 45(1), 570, 2012 |
| 10 |
Thermal performance comparison between radially rotating ribbed parallelogram channels with and without dimples
Chang SW, Liou TM, Lee TH
International Journal of Heat and Mass Transfer, 55(13-14), 3541, 2012 |
