| 1 |
Heat transfer performance of the pin-fin heat sink filled with packed brass beads under a vertical oncoming flow
Jeng TM, Tzeng SC, Huang QY
International Journal of Heat and Mass Transfer, 86, 531, 2015 |
| 2 |
Synthesis of uniform poly(D,L-lactide) and poly(D,L-lactide-co-glycolide) microspheres using a microfluidic chip for comparison
Yang CH, Huang KS, Grumezescu AM, Wang CY, Tzeng SC, Chen SY, Lin YH, Lin YS
Electrophoresis, 35(2-3), 316, 2014 |
| 3 |
Heat transfer characteristics of a rotating cylinder with a lateral air impinging jet
Jeng TM, Tzeng SC, Xu R
International Journal of Heat and Mass Transfer, 70, 235, 2014 |
| 4 |
Experimental study of heat transfer characteristics in a 180-deg round turned channel with discrete aluminum-foam blocks
Jeng TM, Tzeng SC, Xu R
International Journal of Heat and Mass Transfer, 71, 133, 2014 |
| 5 |
Tricking the Guard: Exploiting Plant Defense for Disease Susceptibility
Lorang J, Kidarsa T, Bradford CS, Gilbert B, Curtis M, Tzeng SC, Maier CS, Wolpert TJ
Science, 338(6107), 659, 2012 |
| 6 |
Detailed measurements of heat transfer coefficients in a 180-deg rectangular turned channel with the perforation divider
Jeng TM, Tzeng SC, Yang YC
International Journal of Heat and Mass Transfer, 54(23-24), 4823, 2011 |
| 7 |
Fluid flow and heat transfer characteristics of the porous metallic heat sink with a conductive cylinder partially filled in a rectangular channel
Jeng TM, Tzeng SC, Tang FZ
International Journal of Heat and Mass Transfer, 53(19-20), 4216, 2010 |
| 8 |
Flow visualizations and heat transfer measurements for a rotating pin-fin heat sink with a circular impinging jet
Jeng TM, Tzeng SC, Liao HR
International Journal of Heat and Mass Transfer, 52(7-8), 2119, 2009 |
| 9 |
Heat transfer behavior in a rotating aluminum foam heat sink with a circular impinging jet
Jeng TM, Tzeng SC, Liu TC
International Journal of Heat and Mass Transfer, 51(5-6), 1205, 2008 |
| 10 |
Heat transfer in multi-channels of closed cell aluminum foams
Ma WP, Tzeng SC
Energy Conversion and Management, 48(3), 1021, 2007 |
