| 1 |
Macrosegregation in vertical Bridgman grown Ge1-xSix alloy with large melt volume: Limit of complete mixing
Woodacre JK, Labrie D, Saghir MZ
Journal of Crystal Growth, 327(1), 35, 2011 |
| 2 |
Three-dimensional global modeling of a unidirectional solidification furnace with square crucibles
Liu LJ, Nakano S, Kakimoto K
Journal of Crystal Growth, 303(1), 165, 2007 |
| 3 |
Effect of a rotating magnetic field on the solidified structure of Al-Si alloys
Kovacs J, Roosz A, Szoke J
Materials Science Forum, 508, 263, 2006 |
| 4 |
Experimental performance within the SCA prototype test 1 using ESA's solidification and quench furnace (MSL-SQF) on ground.
Rex S, Hecht U, Drevermann A
Materials Science Forum, 508, 485, 2006 |
| 5 |
Quantitative validation of microstructure simulation in case of unidirectionally solidified Al-Si alloys
Kovacs J, Szoke J, Samu T, Roosz A
Materials Science Forum, 473-474, 355, 2005 |
| 6 |
Unidirectional solidification of a Nb-ss/Nb5Si3 in-situ composite
Guo XR, Guan P, Ding X, Zhang J, Kusabiraki K, Fu HZ
Materials Science Forum, 475-479, 745, 2005 |
| 7 |
Microstructure control of Co3AlC-base heat resistant alloys using optical floating zone melting
Kimura Y, Sakai K, Teramoto S, Mishima Y
Materials Science Forum, 475-479, 833, 2005 |
| 8 |
Power evaluation of PbTe with continuous carrier concentration gradient
Imai Y, Zhu P, Isoda Y, Shinohara Y
Materials Science Forum, 492-493, 145, 2005 |
| 9 |
Eutectic structures in the Ni-Co-Cr-Al system obtained by plasma spraying and by Bridgman growth
Fritscher K
Journal of Crystal Growth, 250(3-4), 546, 2003 |
| 10 |
Solidification of Al-4wt.-%Cu alloy under non-steady-state conditions
Kovacs J, Roosz A, Gacsi Z
Materials Science Forum, 414-4, 133, 2003 |
