| 1 |
발포 폴리프로필렌의 진동융착 강도에 관한 연구
엄찬혁, 하진욱, 정선경, 이재용, 김광섭, 이형탁, 이평찬
Polymer(Korea), 44(3), 364, 2020 |
| 2 |
Experimental investigation on the effects of rotation and the blowing ratio on the leading-edge film cooling of a twist turbine blade
Li HW, Han F, Ma YW, Wang HC, Zhou ZY, Tao Z
International Journal of Heat and Mass Transfer, 129, 47, 2019 |
| 3 |
Computational study of film cooling and flowfields on a stepped vane endwall with a row of cylindrical hole and interrupted slot injections
Xu QZ, Du Q, Wang P, Zhu JQ
International Journal of Heat and Mass Transfer, 134, 796, 2019 |
| 4 |
The characteristics and divergence of fan-shaped and cylindrical holes on the suction side of a turbine blade under rotating conditions
Li HW, Zhao GQ, Zhou ZY, Wang HC, You RQ
International Journal of Heat and Mass Transfer, 139, 432, 2019 |
| 5 |
Film cooling of cylindrical holes on turbine blade suction side near leading edge
Zhou ZY, Li HW, Wang HC, Xie G, You RQ
International Journal of Heat and Mass Transfer, 141, 669, 2019 |
| 6 |
The investigations of slot film outflow used on the laminated cooling configuration
Zhang XD, Liu JJ, An BT
International Journal of Heat and Mass Transfer, 141, 1078, 2019 |
| 7 |
Computational investigation of film cooling and secondary flow on turbine endwall with coolant injection from upstream interrupted slot
Xu QZ, Du Q, Wang P, Liu J, Liu G
International Journal of Heat and Mass Transfer, 123, 285, 2018 |
| 8 |
Effect of ejection angle and blowing ratio on heat transfer and film cooling effect on a winglet tip
Yan X, Huang Y, He K
International Journal of Heat and Mass Transfer, 125, 357, 2018 |
| 9 |
Film cooling performance and flow characteristics of internal cooling channels with continuous/truncated ribs
Xie GN, Liu XT, Yan HB
International Journal of Heat and Mass Transfer, 105, 67, 2017 |
| 10 |
Experimental investigation of rotating film cooling performance in a low speed 1.5-stage turbine
Li GQ, Zhu JQ, Deng HW, Tao Z, Li HW
International Journal of Heat and Mass Transfer, 61, 18, 2013 |
