| 1 |
Mode I cohesive zone model parameters identification and comparison of measurement techniques for robustness to the law shape evaluation
Jaillon A, Jumel J, Paroissien E, Lachaud F
Journal of Adhesion, 96(1-4), 272, 2020 |
| 2 |
Mode I traction-separation measured using rigid double cantilever beam applied to structural adhesive
Watson B, Liao CH, Worswick MJ, Cronin DS
Journal of Adhesion, 96(8), 717, 2020 |
| 3 |
Low velocity oblique impact behavior of adhesively bonded single lap joints
Atahan MG, Apalak MK
Journal of Adhesion Science and Technology, 34(3), 263, 2020 |
| 4 |
Numerical simulation of cement-to-formation interface debonding during hydraulic fracturing of shale gas wells
Lian W, Li J, Liu GH, Tao Q
Journal of Adhesion Science and Technology, 34(9), 917, 2020 |
| 5 |
Strength prediction of adhesively bonded ferrite pillar-tin bronze plate under axial shear loading
Han X, Chao YX, Yang P, Li XY, Zhang W, Jin Y, Wu CW
Journal of Adhesion Science and Technology, 34(6), 616, 2020 |
| 6 |
Failure behaviour of the single lap joints of angle-plied composites under three point bending tests
Kadioglu F, Demiral M
Journal of Adhesion Science and Technology, 34(5), 531, 2020 |
| 7 |
Interfacial fatigue damage behavior of fiber reinforced rubber-A combined experimental and cohesive zone model approach
Yu XM, Zhang B, Gu BQ
Polymer Engineering and Science, 60(6), 1316, 2020 |
| 8 |
Phase and mineral behavior of coke in cohesive zone
Chang ZY, Zhang JL, Ning XJ
Fuel, 253, 32, 2019 |
| 9 |
Direct determination of a new mode-dependent cohesive zone model to simulate metal-to-metal adhesive joints
Gheibi MR, Shojaeefard MH, Googarchin HS
Journal of Adhesion, 95(10), 943, 2019 |
| 10 |
Failure prediction of adhesively bonded CFRP-Aluminum alloy joints using cohesive zone model with consideration of temperature effect
Qin GF, Na J, Tan W, Mu WL, Ji JD
Journal of Adhesion, 95(8), 723, 2019 |
