| 1 |
Integrated optimization of cutting tool and cutting parameters in face milling for minimizing energy footprint and production time
Chen XZ, Li CB, Tang Y, Li L, Du YB, Li LL
Energy, 175, 1021, 2019 |
| 2 |
Characteristics of ZrC/Ni-UDD coatings for a tungsten carbide cutting tool
Chayeuski VV, Zhylinski VV, Rudak PV, Rusalsky DP, Visniakov N, Cernasejus O
Applied Surface Science, 446, 18, 2018 |
| 3 |
Effect of micro/nano-scale textures on anti-adhesive wear properties of WC/Co-based TiAlN coated tools in AISI 316 austenitic stainless steel cutting
Zhang KD, Deng JX, Sun JL, Jiang C, Liu YY, Chen S
Applied Surface Science, 355, 602, 2015 |
| 4 |
Corrosion resistance appraisal of TiN, TiCN and TiAlN coatings deposited by CAE-PVD method on WC-Co cutting tools exposed to artificial sea water
Matei AA, Pencea I, Branzei M, Tranca DE, Tepes G, Sfat CE, Ciovica E, Gherghilescu AI, Stanciu GA
Applied Surface Science, 358, 572, 2015 |
| 5 |
Investigation of thin layers deposited by two PVD techniques on high speed steel produced by powder metallurgy
Jakubeczyova D, Hvizdos P, Selecka M
Applied Surface Science, 258(12), 5105, 2012 |
| 6 |
Compensation control of cutting tool position in machining non-axisymmetric optic mirror surface
Zhang YL, Zhou ZM, Zhang X
Materials Science Forum, 505-507, 181, 2006 |
| 7 |
Development of a novel micro wire-EDM mechanism for the fabricating of micro parts
Lin CS, Liao YS, Chen ST
Materials Science Forum, 505-507, 235, 2006 |
| 8 |
Surface integrity of H13 ESR mould steel milled by carbide and CBN tools
Marques MJ, Outeiro J, Dias AM, Saoubi RM, Chandrasekaran H
Materials Science Forum, 514-516, 564, 2006 |
| 9 |
The mathematical modeling of the compressive stresses on the cutting tool in machining of Inconel 718
Seker U, Kurt A
Materials Science Forum, 526, 229, 2006 |
| 10 |
Development of nano-TiN modified cermet cutter
Xie F, Yang HD, Zhang CG, Liu N
Materials Science Forum, 471-472, 711, 2004 |
