| 1 |
Micro- and nano-morphological modification of aluminum surface for adhesive bonding to polymeric composites
Kim WS, Kim KH, Jang CJ, Jung HT, Lee JJ
Journal of Adhesion Science and Technology, 27(15), 1625, 2013 |
| 2 |
Measurement of interfacial toughness of metal film wire and polymer membrane through electricity induced buckling method
Wang QH, Xie HM, Lu J, Chen PW, Zhang QM
Journal of Colloid and Interface Science, 358(2), 491, 2011 |
| 3 |
Nanomechanical characterization of sputtered RuO2 thin film on silicon substrate for solid state electronic devices
Zhu J, Yeap KB, Zeng KY, Lu L
Thin Solid Films, 519(6), 1914, 2011 |
| 4 |
A non-contact, thermally-driven buckling delamination test to measure interfacial fracture toughness of thin film systems
Goyal S, Srinivasan K, Subbarayan G, Siegmund T
Thin Solid Films, 518(8), 2056, 2010 |
| 5 |
Important Aspects of Bonding Resin to Dental Ceramics
Della Bona A
Journal of Adhesion Science and Technology, 23(7-8), 1163, 2009 |
| 6 |
Finite element analysis of contact induced adhesion failure in multilayer coatings with weak interfaces
Chen JJ, Bull SJ
Thin Solid Films, 517(13), 3704, 2009 |
| 7 |
Interfacial characterization of catalyst coating on electrolyte polymer through microscratch analysis in DMFC
Lee G, Lee H, Kwon D
Electrochimica Acta, 52(12), 4215, 2007 |
| 8 |
Analysis of the influence of atmospheric plasma spray (APS) parameters on adhesion properties of alumina-titania coatings
Guessasma S, Montavon G, Coddet C
Journal of Adhesion Science and Technology, 18(4), 495, 2004 |
| 9 |
Peel testing of adhesively bonded thin metallic plates with control of substrate plastic straining and of debonding mode mixity
Sener JY, Van Dooren F, Delannay F
Journal of Adhesion Science and Technology, 15(10), 1165, 2001 |
| 10 |
Is there any contradiction between the stress and energy failure criteria in micromechanical tests? Part I. Crack initiation: stress-controlled or energy-controlled?
Zhandarov S, Pisanova E, Lauke B
Composite Interfaces, 5(5), 387, 1998 |
