1 |
Measuring particle size distribution and mass concentration of nanoplastics and microplastics: addressing some analytical challenges in the sub-micron size range Caputo F, Vogel R, Savage J, Vella G, Law A, Della Camera G, Hannon G, Peacock B, Mehn D, Ponti J, Geiss O, Aubert D, Prina-Mello A, Calzolai L Journal of Colloid and Interface Science, 588, 401, 2021 |
2 |
Effect of particle concentration on the stability of water-based SiO2 nanofluid Zhang TC, Zou QL, Cheng ZH, Chen ZH, Liu Y, Jiang ZB Powder Technology, 379, 457, 2021 |
3 |
Coupled CFD-DEM simulation of granular LCM bridging in a fracture Zhu BY, Tang HM, Wang X, Zhao F, Yuan XF Particulate Science and Technology, 38(3), 371, 2020 |
4 |
Three-way coupling of fine particle deposition behavior on a rib-roughened surface Hong WP, Liu Y, Wang BH, Li HR Powder Technology, 372, 420, 2020 |
5 |
Investigation of the pressure drop increase in a square free-vortex cyclonic separator operating at low particle concentration Haake J, Oggian T, Utzig J, Rosa LM, Meier HF Powder Technology, 374, 95, 2020 |
6 |
The effect of the secondary air injection on the gas-solid flow characteristics in the circulating fluidized bed Zheng WJ, Zhang M, Zhang Y, Lyu JF, Yang HR Chemical Engineering Research & Design, 141, 220, 2019 |
7 |
Study on the combustion characteristics of a two-dimensional particle group for coal char and petroleum coke particles Shen ZJ, Liang QF, Xu JL, Liu HF, Lin KF Fuel, 253, 501, 2019 |
8 |
Numerical analysis of the heat transfer and fluid flow characteristics of a nanofluid-cooled micropin-fin heat sink using the Eulerian-Lagrangian approach Ambreen T, Saleem A, Park CW Powder Technology, 345, 509, 2019 |
9 |
Case study on the influence of electrostatic charges on particle concentration in turbulent duct flows Grosshans H, Villafane L, Banko A, Papalexandris MV Powder Technology, 357, 46, 2019 |
10 |
Intensification of sonochemical reactions in solid-liquid systems under fully suspended condition Stoian D, Eshtiaghi N, Wu J, Parthasarathy R Chemical Engineering and Processing, 123, 34, 2018 |