| 1 |
In situ TPU/graphene nanocomposites: Correlation between filler aspect ratio and phase morphology
Rohm K, Bonab VS, Manas-Zloczower I
Polymer Engineering and Science, 61(4), 1018, 2021 |
| 2 |
Evaluation of healing models to predict the weld line strength of the amorphous thermoplastic polystyrene by injection molding simulation
Onken J, Verwaayen S, Hopmann C
Polymer Engineering and Science, 61(3), 754, 2021 |
| 3 |
Effects of radiation type and dose on the properties of selected polymers
Burgstaller C, Hoftberger T, Gallnbock-Wagner B, Stadlbauer W
Polymer Engineering and Science, 61(1), 39, 2021 |
| 4 |
Processing of Carbon Fiber Reinforced Thermoplastics into Granules for Reuse in Structural Components
Zollner M, Krampitz T, Lieberwirth H
Chemie Ingenieur Technik, 92(4), 459, 2020 |
| 5 |
Open-tubular nanoelectrochromatography (OT-NEC): gel-free separation of single stranded DNAs (ssDNAs) in thermoplastic nanochannels
Amarasekara CA, Athapattu US, Rathnayaka C, Choi J, Park S, Soper SA
Electrophoresis, 41(18-19), 1627, 2020 |
| 6 |
Fabrication and Analysis of Long Fiber Reinforced Polypropylene Prepared via Injection Molding
Park SY, Song YS
Macromolecular Research, 28(8), 714, 2020 |
| 7 |
Theoretical and experimental study onthree-layeredpolymeric balloon catheter processing
Jin GB, Hua WJ, Wang KS, Xu CX, Bian JY, Dai GH, Qin P, Jin YF
Polymer Engineering and Science, 60(12), 3244, 2020 |
| 8 |
Mold replication in injection molding of high density polyethylene
Quadrini F, Bellisario D, Santo L, Bottini L, Boschetto A
Polymer Engineering and Science, 60(10), 2459, 2020 |
| 9 |
Cell structures, phase morphologies and impact toughness of phenolphthalein poly(ether ether ketone)/epoxy composite foams
Ding YY, Zhou CQ, Ren BS, Zhang AM, Wang GL
Polymer Engineering and Science, 60(9), 2133, 2020 |
| 10 |
Investigation of thermoplastic melt flow and dimensionless groups in 3D bioplotting
Gopi S, Kontopoulou M
Rheologica Acta, 59(2), 83, 2020 |
