| 2863 - 2863 |
Guest editorial for a special issue on alternative energy dimensions
Nizetic S |
| 2864 - 2874 |
Development and analysis of a new integrated solar energy system with thermal storage for fresh water and power production
Demir ME, Dincer I |
| 2875 - 2900 |
Performance analysis of an integrated solar-based power generation plant using nanofluids
Alashkar A, Gadalla M |
| 2901 - 2915 |
Performance analysis of solar assisted multi-effect absorption cooling systems using nanofluids: A comparative analysis
Ratlamwala TAH, Abid M |
| 2916 - 2926 |
Environmental, economic and exergetic sustainability assessment of power generation from fossil and renewable energy sources
Stougie L, Giustozzi N, van der Kooi H, Stoppato A |
| 2927 - 2939 |
Correlation studies between pore structure and electrochemical performance of activated polymer-based hard carbon with various organic and aqueous electrolytes
Baek J, An KH, Chung DC, Kim BJ |
| 2940 - 2952 |
Hydrogen production from coal-derived syngas undergoing high-temperature water gas shift reaction in a membrane reactor
Chein RY, Chen WH |
| 2953 - 2960 |
Effect of temperature on behavior of perovskite-type oxide LaGaO3 used as a novel anode material for Ni-MH secondary batteries
Kaabi A, Tliha M, Dhahri A, Khaldi C, Fenineche N, Elkedim O, Lamlouli J |
| 2961 - 2970 |
Intermetallic Ni3Sn4-based graphene@carbon hybrid composites for lithium-ion batteries
Guler MO, Guzeler M, Guler A, Nalci D, Duman SO, Singil MM, Alkan E, Dogan M, Akbulut H |
| 2971 - 2982 |
Graphene assisted template based LiMn2O4 flexible cathode electrodes
Guler A, Duman SO, Nalci D, Guzeler M, Bulut E, Guler MO, Akbulut H |
| 2983 - 2996 |
Simulation analysis of the catalytic cracking process of biomass pyrolysis oil with mixed catalysts: Optimization using the simplex lattice design
Jaroenkhasemmeesuk C, Diego ME, Tippayawong N, Ingham DB, Pourkashanian M |
| 2997 - 3006 |
The effect of salinity concentration on algal biomass production and nutrient removal from municipal wastewater by Dunaliella salina
Liu Y, Yildiz I |
| 3007 - 3016 |
Research for intake and exhaust system parameterization of 2-cylinder gasoline engine for RE-EV
Jang J, Woo Y, Jung Y, Cho C, Kim G, Pyo Y, Han M, Lee S |
| 3017 - 3029 |
Thermodynamic analysis of active modular internal combustion engine concept: Targeting efficiency increase and carbon dioxide emissions reduction of gasoline engines
Matulic N, Radica G, Nizetic S |
| 3030 - 3047 |
Multiobjective optimization of a building envelope with the use of phase change materials (PCMs) in Mediterranean climates
Konstantinidou CA, Lang W, Papadopoulos AM |
| 3048 - 3058 |
Investigations of the thermal performance of a cylindrical wicked heat pipe
Grissa K, Benselama AM, Lataoui Z, Bertin Y, Jemni A |
| 3059 - 3067 |
Design and experimental evaluation of a travelling-wave thermoacoustic refrigerator driven by a cascade thermoacoustic engine
Dhuchakallaya I, Saechan P |
| 3068 - 3077 |
Life cycle analysis (LCA) and life cycle cost analysis (LCCA) of phase change materials (PCM) for thermal applications: A review
Kyriaki E, Konstantinidou C, Giama E, Papadopoulos AM |
| 3078 - 3090 |
Investigation of new mechanical heat pump systems for heat upgrading applications
Singh V, Dincer I, Rosen MA |
| 3091 - 3101 |
Effect of encapsulated ice thermal storage system on cooling cost for a hypermarket
Erdemir D, Altuntop N |
| 3102 - 3120 |
A data-driven statistical approach for extending electric vehicle charging infrastructure
Pevec D, Babic J, Kayser MA, Carvalho A, Ghiassi-Farrokhfal Y, Podobnik V |
| 3121 - 3142 |
A feasibility study of Organic Rankine Cycle (ORC) power generation using thermal and cryogenic waste energy on board an LNG passenger vessel
Tsougranis EL, Wu DW |
