| 3599 - 3612 |
Hydrogen and synthetic fuel production using high temperature solid oxide electrolysis cells (SOECs)
Kazempoor P, Braun RJ |
| 3613 - 3623 |
HxMoO3@C nanobelts: Green synthesis and superior lithium storage properties
Song YP, Wang H, Li ZH, Ye NQ, Wang LJ, Liu Y |
| 3624 - 3632 |
Mixed ionic electronic conducting powder bed for grid level energy storage and release: A study of tungsten oxide reduction kinetics
Milshtein JD, Gergel DR, Basu SN, Pal UB, Gopalan S |
| 3633 - 3641 |
Influence of La on reduction behaviour and Ni metal surface area of Ni-Al2O3 catalysts for COx free H-2 by catalytic decomposition of methane
Anjaneyulu C, Kumar SN, Kumar VV, Naresh G, Bhargava SK, Chary KVR, Venugopal A |
| 3642 - 3647 |
Optimisation of hydrogen production by steam reforming of chars derived from lumber and agricultural residues
Klaas M, Greenhalf C, Ferrante L, Briens C, Berruti F |
| 3648 - 3658 |
Biomass residues as raw material for dark hydrogen fermentation - A review
Urbaniec K, Bakker RR |
| 3659 - 3671 |
Influence of chemical treatments of activated carbon support on the performance and deactivation behavior of promoted Ru catalyst in ammonia synthesis
Jafari A, Saadatjou N, Sahebdelfar S |
| 3672 - 3678 |
Visible light photocatalysis by in situ growth of plasmonic Ag nanoparticles upon AgTaO3
Xu XX, Liu G, Azad AK |
| 3679 - 3688 |
TiO2 nanofibers heterogeneously wrapped with reduced graphene oxide as efficient Pt electrocatalyst supports for methanol oxidation
Zhuang W, He LJ, Zhu JH, An R, Wu XB, Mu LW, Lu XH, Lu LH, Liu XJ, Ying HJ |
| 3689 - 3696 |
Porphyrin-based porous sheet: Optoelectronic properties and hydrogen storage
Zhu GZ, Sun Q, Kawazoe Y, Jena P |
| 3697 - 3707 |
Preparation technique and alloying effect of aluminide coatings as tritium permeation barriers: A review
Xiang X, Wang XL, Zhang GK, Tang T, Lai XC |
| 3708 - 3718 |
Electronic modeling of a PEMFC with logarithmic amplifiers
Alberro M, Marzo FF, Manso AP, Dominguez V, Barranco J, Garikano X |
| 3719 - 3725 |
Solid - state electrochemical heat engines
Richards G, Gemmen RS, Williams MC |
| 3726 - 3738 |
K44M ferritic stainless steel as possible interconnect material for SOFC stack operating at 600 degrees C: Characterization of the oxidation behaviour at early working stages
Piccardo P, Anelli S, Bongiorno V, Spotorno R, Repetto L, Girardon P |
| 3739 - 3748 |
Water transport in a PEM fuel cell with slanted channel flow field plates
Wawdee P, Limtrakul S, Vatanatham T, Fowler MW |
| 3749 - 3761 |
Preparation, characterization and properties of polymer electrolyte nanocomposite membranes containing silica nanoparticles modified via surface-initiated atom transfer radical polymerization
Shahabadi R, Abdollahi M, Sharif A |
| 3762 - 3770 |
First-principles calculation of the structural, electronic, dynamical and thermodynamic properties of gamma-LiAlO2
Ma SG, Shen YH, Gao T, Chen PH |
| 3771 - 3776 |
Maximum thrust for the rocket-ejector mode if the hydrogen fueled rocket-based combined cycle engine
Yang QC, Shi W, Chang JT, Bao W |
| 3777 - 3788 |
Detailed influences of chemical effects of hydrogen as fuel additive on methane flame
Ying YY, Liu D |
| 3789 - 3796 |
Simultaneous dissociation of CO2 and H2O to syngas in a surface-wave microwave discharge
Chen GX, Silva T, Georgieva V, Godfroid T, Britun N, Snyders R, Delplancke-Ogletree MP |
