International Polymer Processing

International Polymer Processing, Vol.32, No.1 Entire volume, number list

ISSN: 0930-777X (Print)

In this Issue (17 articles)

2 - 2	New Associate Editor for the Americas Covas JA
3 - 10	Effect of Flow Induced Orientation of Carbon Nanotubes on the Capillary Extrusion Behavior of Low-Density Polyethylene Uematsu H, Natsuume T, Tanoue S, Iemoto Y
11 - 19	Mullins Effect under Compression Mode and its Reversibility of Thermoplastic Vulcanizate Based on Ethylene-Vinyl Acetate Copolymer/ Styrene-Butadiene Rubber Blend Wang CC, Zhang YF, Liu QQ, Wang ZB
20 - 25	Bio-Based Hybrid Polymers from Vinyl Ester Resin and Modified Palm Oil: Synthesis and Characterization Fakhari A, Rahmat AR, Wahit MU, Arjmandi R
26 - 33	Study on Crystal Form Transition and Non-Isothermal Crystallization of Glycidyl Methacrylate Grafted Isotactic Polybutene-1 Zhao YX, Xu W, Zhou YF, Chen JY, Han L, Li D
34 - 40	Flashing Method for Fabricating Micro Scale Fibers, Spheres, Porous and Condensed Polymer Structures Porwal R, Bellare JR
41 - 49	Preparation and Performance Evaluation of SPEEK/Polyaniline Composite Membrane for Direct Methanol Fuel Cell Sultan AS, Adewole JK, Al-Ahmed A, Nazal M, Zaidi SMJ
50 - 57	Rotational Molding of Linear Low Density Polyethylene ( LLDPE) Fumed Silica Nanocomposites Chandran VG, Waigaonkar SD
58 - 71	Design Guidelines to Balance the Flow Distribution in Complex Profile Extrusion Dies Rajkumar A, Ferras LL, Fernandes C, Carneiro OS, Becker M, Nobrega JM
72 - 83	Microstructure and Mechanical Properties of Nanocomposite Based on Polypropylene/Ethylene Propylene Diene Monomer/Graphene Haghnegahdar M, Naderi G, Ghoreishy MHR
84 - 89	An Engineering Model that Simulates Pantographing Occurring in the Shaping Process of Reinforced Uncured Rubber Parts Debbaut B
90 - 101	The Influence of Different Melt Temperatures on the Mechanical Properties of Injection Molded PA-12 and the Post Process Detection by Thermal Analysis Meyer T, Harland A, Haworth B, Holmes C, Lucas T, Sherratt P
102 - 111	Morphology and Thermal Behavior of TPU/PP Blends Modified with Maleic Anhydride Grafted SEBS-g-MA Block Copolymer Bulatovic VO, Mihaljevic A, Bajsic EG, Holjevac TG
112 - 120	Extrusion Blow Molding of Polymeric Blends Based on Thermotropic Liquid Crystalline Polymer and High Density Polyethylene Qian C, Mansfield CD, Baird DG
121 - 128	Characterization of Stereocomplex Polylactide/Nanoclay Nanocomposites Srithep Y, Pholharn D, Turng LS
129 - 137	Attempts to Optimize the Dispersion State during Twin-Screw Extrusion of Polypropylene/Clay Nanocomposites Normand G, Peuvrel-Disdier E, Vergnes B
138 - 142	Improved Layer Mechanical Properties of Micro Injection Molded PP Ma SJ, Wang SW, Zhang Q, Li Q