| 122 - 131 |
Functionalization of low density polyethylene with ricinol-2-oxazoline methyl maleate in a twin-screw extruder
Jeziorska R |
| 132 - 139 |
Modelling of phase transitions and residual thermal stress of CTBN rubber modified epoxy resins during a pultrusion process
Calabrese L, Valenza A |
| 140 - 145 |
Real-time diagnosis of micro powder injection molding using integrated ultrasonic sensors
Cheng CC, Ono Y, Whiteside BD, Brown EC, Jen CK, Coates PD |
| 146 - 150 |
Rheological behavior of HEUR mixtures in aqueous media
Barmar M, Kaffashi B |
| 151 - 154 |
Spinnability and dyeability for copolymer/nano-SiO2 fiber of glycol and 1,2-propanediol with PTA
Wu J, Chen Y, Li Z, Li S |
| 155 - 165 |
Development of a novel transcription molding process to fabricate sophisticated polymer products with precise microstructure and high transparency applicable to display devices and bio-chips
Ito H, Satoh I, Saito T, Yakemoto K |
| 166 - 172 |
Effect of aspect ratio of whisker on the fibrillation of liquid crystalline polymer in polysulfone matrix
Chen J, Chen P, Wu L, Zhang J, He J |
| 173 - 178 |
Gas assisted injection molding of an industrial part: 3D simulation provides virtual molding trials
Polynkin A, Pittman JFT, Sienz J |
| 179 - 189 |
Analysis of film blowing with flow-enhanced crystallization - Part 1. Steady-state behavior
Henrichsen LK, McHugh AJ |
| 190 - 197 |
Analysis of film blowing with flow-enhanced crystallization - Part 2. Linearized sensitivity and stability behavior
Henrichsen LK, McHugh AJ |
| 198 - 203 |
A composite model for melting, pressure and fill factor profiles in a metered fed closely intermeshing counter-rotating twin screw extruder
Wilczynski K, Jiang Q, White JL |
| 204 - 212 |
Surface defects of TPO injected foam parts for automotive applications
Santoni A, Guo MC, Heuzey MC, Carreau PJ |
