| 218 - 222 |
Investigation of the Thickening Efficiency of HEUR on the Behavior of Two Different Latex Types
Barmar M, Barikani M |
| 223 - 233 |
Optimization of the Thickness of PET Bottles during Stretch Blow Molding by Using a Mesh-free (Numerical) Method
Cosson B, Chevalier L, Yvonnet J |
| 234 - 241 |
An Experimental Setup to Measure the Transient Temperature Profiles in Water Assisted Injection Molding
Liu SJ, Su PC |
| 242 - 252 |
Experimental Investigation and Flow Modeling of Slippage Induced by Additives in Polyolefins in a Modular Co-rotating Twin Screw Extruder
Ban K, Bumm SH, White JL |
| 253 - 260 |
In-mold Melt Front Rate Control Using a Capacitive Transducer in Injection Molding
Zhou F, Yao K, Chen X, Gao F |
| 261 - 266 |
Structural and Rheological Properties as a Function of Mixing Energy for Polymer/Layered Silicate Nanocomposites
Mederic P, Aubry T, Razafinimaro T |
| 267 - 271 |
Study on Kneading and Molding of PP/TiO2 Nanocomposite
Huang CK, Cheng FS |
| 272 - 279 |
Sustainable Biocomposites from Rice Flour and Sisal Fiber: Effect of Fiber Loading, Length and Alkali Treatment
Lopattananon N, Songkaew S, Thongruang W, Seadan M |
| 280 - 287 |
On-line Measurement Studies on Orientation Development and Characteristic Short-Period Diameter Fluctuation in High Speed In-line Drawing of Poly(ethylene terephthalate) Fiber
Hahm WG, Takarada W, Ito H, Kikutani T |
| 288 - 297 |
Micro Replication by Injection-Compression Molding
Rohde M, Derdouri A, Kamal MR |
| 298 - 305 |
Utilizing Processing Parameters for Evaluating Polymer Viscosity during Plastication in Injection Molding
Dubay R, Zhang D, Hernandez JM |
