| 434 - 441 |
Heat Transfer Coefficient in Injection Molding of Polymers
Heinle M, Drummer D |
| 442 - 450 |
Using the GPU to Design Complex Profile Extrusion Dies
Goncalves ND, Pereira SP, Ferras LL, Nobrega JM, Carneiro OS |
| 451 - 459 |
Dispersive Mixing Performance Evaluation of Special Rotor Segments in an Intermeshing Co-Rotating Twin-Screw Extruder by Using Weighted Probability Distributions
Yamada S, Fukutani K, Yamaguchi K, Funahashi H, Ebata K, Uematsu H, Tanoue S |
| 460 - 466 |
Estimation of Bulk Melt-Temperature from In-Mold Thermal Sensors for Injection Molding, Part A: Method
Johnston SP, Mendible GA, Gao RX, Kazmer DO |
| 467 - 475 |
Mechanical Properties, Morphologies and Thermal Decomposition Kinetics of Poly(lactic acid) Toughened by Waste Rubber Powder
Yang JN, Nie SB, Ding GX, Wang ZF, Gao JS, Zhu JB |
| 476 - 486 |
Lithium Ion Conduction in PVdC-co-AN Based Polymer Blend Electrolytes Doped with Different Lithium Salts
Subbu C, Rajendran S, Kesavan K, Mathew CM |
| 487 - 499 |
Stretch Blow Molding of Mineral Filled PET
Billon N, Haudin JM, Vallot C, Babin C |
| 500 - 510 |
Enhanced Film Blowing of Polylactide by Incorporating Branched Chains and Stereocomplex Crystals
Nouri S, Lafleur PG, Dubois C |
| 511 - 521 |
Development of Antimicrobial Poly(epsilon-caprolactone)/Poly(lactic acid)/Silver Exchanged Montmorillonite Nanoblend Films with Silver Ion Release Property for Active Packaging Use
Benhacine F, Hadj-Hamou AS, Habi A, Grohens Y |
| 522 - 527 |
Impact of Humid Environment on Structural and Mechanical Properties of Biobased Polylactide
Jaszkiewicz A, Bledzki AK, Meljon A |
