| 693 - 704 |
Removal of temporary cements following an immediate dentin hybridization approach: a comparison of mechanical and chemical methods for substrate cleaning
Augusti D, Re D, Ozcan M, Augusti G |
| 705 - 720 |
Characteristics of simultaneous epoxy-novolac full interpenetrating polymer network (IPN) adhesive
Ahmed S, Chakrabarty D, Mukherjee S, Bhowmik S |
| 721 - 738 |
Progressive failure of bamboo-steel adhesive bonding interface subjected low-energy impact and tension in sequence
Zhang ZW, Li YS, Liu R, Zhang JL |
| 739 - 752 |
Analysis of agglomeration and interfacial properties in PBT/nano-Sb2O3 composites
Yang WL, Xu JL, Niu L, Kang CH, Ma BX |
| 753 - 771 |
Reliable thin chip peeling from adhesive tape with inverted needle ejecting and spring buffering
Hong JH, Chen JK, Xu ZL, Yin ZP |
| 772 - 786 |
Online monitoring of the curing of adhesives with a miniaturised interdigital sensor using impedance spectroscopy
Hubner M, Dumstorff G, Mogaddam MK, Plagemann P, Lang W |
| 787 - 800 |
Chloride penetration through cement material based on dredged sediment and shell powder
Ez-zaki H, Diouri A |
