| 363 - 375 |
Electro-organic reactions. Part 60[1]. The electro-oxidative conversion at laboratory scale of a lignosulfonate into vanillin in an FM01 filter press flow reactor: preparative and mechanistic aspects
Smith CZ, Utley JHP, Hammond JK |
| 377 - 382 |
Poly(2,5-dimercapto-1,3,4-thiadiazole)/sulfonated graphene composite as cathode material for rechargeable lithium batteries
Jin LF, Wang GC, Li XW, Li LB |
| 383 - 388 |
Inhibiting effect of cerium ions on corrosion of 3003 aluminum alloy in ethylene glycol-water solutions
Liu Y, Cheng YF |
| 389 - 395 |
A novel perforated electrode flow through cell design for chlorine generation
Nath H, Wang XJ, Torrens R, Langdon A |
| 397 - 403 |
Electrochromism in composite WO3-Nb2O5 thin films synthesized by spray pyrolysis technique
Mujawar SH, Inamdar AI, Betty CA, Korosec RC, Patil PS |
| 405 - 413 |
Investigation of N-2-fixation on polyaniline electrodes in methanol by electrochemical impedance spectroscopy
Koleli F, Ropke D, Aydin R, Ropke T |
| 415 - 422 |
The influence of citrate and tartrate on the electrodeposition and surface morphology of Cu-Ni layers
Melo LC, de Lima-Neto P, Correia AN |
| 423 - 433 |
Molecular modeling and electrochemical investigations of the corrosion inhibition of nickel using some thiosemicarbazone derivatives
Khaled KF |
| 435 - 444 |
Effect of pre-treatment approach of a carbon support on activity of PtSn/C electrocatalysts for direct ethanol fuel cells
Thepkaew J, Therdthianwong S, Therdthianwong A |
| 445 - 452 |
Solid-state dye-sensitized ZnO solar cells prepared by low-temperature methods
Selk Y, Minnermann M, Oekermann T, Wark M, Caro J |
| 453 - 460 |
Improved high-rate cyclability of sol-gel derived Cr-doped spinel LiCr (y) Mn2-y O-4 in an aqueous electrolyte
Xu WM, Yuan AB, Tian L, Wang YQ |
| 461 - 468 |
Corrosion- and wear-resistant properties of Ni-Al2O3 composite coatings containing various forms of alumina
Aruna ST, Selvi VE, Grips VKW, Rajam KS |
| 469 - 480 |
Effect of the deposition parameters on the voiding propensity of solder joints with Cu electroplated in a Hull cell
Wafula F, Liu Y, Yin L, Borgesen P, Cotts EJ, Dimitrov N |
| 481 - 490 |
Effect of ionic liquid additive [BMIM]HSO4 on zinc electrodeposition from impurity-containing sulfate electrolyte. Part I: current efficiency, surface morphology, and crystal orientations
Zhang QB, Hua YX |
