| 281 - 288 |
A novel approach to dynamic representation of drill strings in test rigs
Elsayed MA |
| 289 - 299 |
Planning 3D well trajectories using spline-in-tension functions
Sampaio JHB |
| 300 - 306 |
A computational method for planar kinematic analysis of beam pumping units
Bhagavatula R, Fashesan OA, Heinze LR, Lea JF |
| 307 - 313 |
Experimental study of composting oil wet drill cuttings as a drilling waste disposal option
Sorheim R, Paulsen JE, Saasen A, Leleux J, Albouy A, Haraldsen TK, Pedersen PA, Hartnik T, Linjordet R |
| 314 - 324 |
Transient optimization in natural gas compressor stations for linepack operation
Abbaspour M, Krishnaswami P, Chapman KS |
| 325 - 331 |
Combustion characteristics of compression engine driven by emulsified fuel under various fuel injection angles
Ashok MP, Saravanan CG |
| 332 - 337 |
Improving ethanol life cycle energy efficiency by direct utilization of wet ethanol in HCCI engines
Martinez-Frias J, Aceves SM, Flowers DL |
| 338 - 347 |
Charcoal-adsorption, water-washing, and air-dilution systems to reduce diesel emissions with special emphasis on odor reduction
Roy MM |
| 348 - 354 |
Optimum criteria on the important parameters of an irreversible otto heat engine with the temperature-dependent heat capacities of the working fluid
Zhao YR, Lin BH, Chen JC |
| 355 - 359 |
Modeling of chemical processes in a diesel engine with alcohol fuels
Yilmaz N, Donaldson AB |
| 360 - 363 |
Analysis of energy harvesting positive displacement motor
Samuel GR |
| 364 - 365 |
Design improvements to a Biomass Stirling engine using mathematical analysis and 3D CFD modeling - Discussion
Mahkamov K |
