Journal of Materials Science

Journal of Materials Science, Vol.33, No.2 Entire volume, number list

ISSN: 0022-2461 (Print)

In this Issue (33 articles)

281 - 285	Prolonged plastic deformation related to the microindentation of MgO single crystals Boyarskaya YS, Zhitaru RP, Grabko DZ, Rahvalov VA
287 - 303	Orientation-dependent mechanical properties and deformation morphologies for uniaxially melt-extruded high-density polyethylene films having an initial stacked lamellar texture Zhou HY, Wilkes GL
305 - 312	Characteristic times of oxygen mass transfer at the liquid metal vapour interface Ricci E, Nanni L, Arato E, Costa P
313 - 318	Fracture characteristic of a (Si-Al-O-N)-SiC composite studied by transmission electron microscopy Lee BT
319 - 327	Load-adaptive crystalline-amorphous nanocomposites Voevodin AA, Zabinski JS
329 - 337	The effect of liquid gallium on the strengths of stainless steel and thermoplastics Narh KA, Dwivedi VP, Grow JM, Stana A, Shih WY
339 - 345	CuInSe2 thin films formed by selenization of Cu-In precursors Calixto ME, Sebastian PJ
347 - 355	Effects of pre-existent crack in double and gradient coatings on the crack extension into fibre and interfacial debonding Ochiai S, Hojo M
357 - 362	EPR and magnetic susceptibility studies of Cr2O3-Bi2O3-GeO2 glasses Ardelean I, Peteanu M, Simon V, Bob C, Filip S
363 - 370	Sputtered lead scandium tantalate thin films : a microstructural study Huang Z, Todd MA, Watton R, Whatmore RW
371 - 378	Undercooling in Co-Cu alloys and its effect on solidification structure Yamauchi I, Ueno N, Shimaoka M, Ohnaka I
379 - 384	Interactions of thin films of Pd and Pd/Si on GaAs : an X-ray photoelectron spectroscopic study combined with a thermodynamic analysis Iwakuro H, Kuroda T, Shen DH, Yagi H
385 - 394	Effects of Cu addition on the beta-phase formation rate in Fe2Si5 thermoelectric materials Yamauchi I, Okamoto H, Suganuma A, Ohnaka I
395 - 403	The effect of tempering temperature on mechanical properties and microstructure of low alloy Cr and CrMo steel Gojic M, Kosec L, Matkovic P
405 - 415	ESEM observations of SCC initiation for 4340 high strength steel in distilled water Atrens A, Wang ZF
417 - 421	Effect of copper on the electrical properties of K-1.6(Mg1-yCuy)(0.8)Ti7.2O16 ceramics Yoon KH, Han S, Kang DH, Kim TH
423 - 427	Strength of beta-sialon/Si3N4 layered composites Goto Y, Fukasawa T, Kato M
429 - 433	Preparation and high-temperature behaviour of electrolytic alumina film on Fe-Cr-Al stainless steel Aries L, Roy J, El Hajjaji S, Alberich L, Hernandez PV, Costeseque P, Aigouy T
435 - 439	Pressure-pulsed chemical vapour infiltration of pyrolytic carbon into porous carbon or two-dimensional-carbon/SiC particulate preforms from C6H6-H-2-N-2 Ohzawa Y, Watabe K, Sugiyama K
441 - 444	Mechanical properties of flo-deflocculated and milled powders in the Al2O3/ZrO2(CeO2) system Burelli M, Maschio S, Meriani S
445 - 452	Surface free energy components of silica gel determined by the thin layer wicking method for different layer thicknesses of gel Holysz L
453 - 461	Influence of a fine talc on the properties of composites with high density polyethylene and polyethylene/polystyrene blends Karrad S, Cuesta JML, Crespy A
463 - 469	Combined effects of cerium and boron on the mechanical properties and oxidation behaviour of Ni3Al alloy Yuan ZX, Song SH, Faulkner RG, Yu ZS
471 - 476	ZnS precipitation : morphology control Bredol M, Merikhi J
477 - 486	Determination of porosity of reduced hematite by stereologic methods Janowski J, Sadowski A, Kraj W, Ratajczak T
487 - 496	Scanning tunnelling microscopy and transmission electron microscopy study of ultrafine structure and surface relief of bainite in a Cu-Zn-Al alloy Li CM, Fang HS, Yang ZG, Bo XZ, Wang JJ, Zheng YK
497 - 505	Effect of rare-earth elements on the microstructural characterization in rapidly quenched thermally strengthened aluminium alloys Wang JQ, Zhang BJ, Tseng MK, Doncel GG
507 - 513	Hexavalent chromium in tricalcium silicate - Part I - Quantitative X-ray diffraction analysis of crystalline hydration products Omotoso OE, Ivey DG, Mikula R
515 - 522	Hexavalent chromium in tricalcium silicate - Part II - Effects of Cr-VI on the hydration of tricalcium silicate Omotoso OE, Ivey DG, Mikula R
523 - 528	Nanosecond pulsed excimer laser machining of chemically vapour-deposited diamond and graphite - Part II - Analysis and modelling Windholz R, Molian PA
529 - 533	Synthesis of TiO2 and TiN nanosize powders by intense light ion-beam evaporation Nakagawa Y, Grigoriu C, Masugata K, Jiang WH, Yatsui K
535 - 547	A theoretical and experimental approach to the active-to-passive transition in the oxidation of silicon carbide - Experiments at high temperatures and low total pressures Schneider B, Guette A, Naslain R, Cataldi M, Costecalde A
549 - 558	Perovskite-type BaTiO3 ceramics containing particulate SiC - Part II - Microstructure and mechanical properties Hwang HJ, Niihara K