| 1945 - 1967 |
Structural Investigations of Phosphate-Glasses - A Detailed Infrared Study of the X(PbO)-(1-X)P2O5 Vitreous System
Dayanand C, Bhikshamaiah G, Tyagaraju VJ, Salagram M, Murthy AS |
| 1969 - 1983 |
Grain-Size and Porosity Dependence of Ceramic Fracture Energy and Toughness at 22-Degrees-C
Rice RW |
| 1985 - 1989 |
Characterization of Side-Chain Liquid-Crystal Polymers Using Dynamic-Mechanical Thermal-Analysis and Dielectric Thermal-Analysis
Mulligan DR, Imrie CT, Larcey P |
| 1991 - 1996 |
A Study of Hydrogen Sites in Amorphous-Semiconductors by Musr - A Novel Repolarization Curve Technique
Singh A |
| 1997 - 2007 |
Microstructures and Room-Temperature Mechanical-Properties of NiAl Prepared by High-Pressure Reaction Sintering
Cheng TY |
| 2009 - 2017 |
Synthesis and Microstructure of Nanostructured Al/Al2O3(H)-Composite
Veith M, Faber S, Hempelmann R, Janssen S, Prewo J, Eckerlebe H |
| 2019 - 2026 |
Evidence for a Nonthermal Microwave Effect in the Sintering of Partially-Stabilized Zirconia
Wroe R, Rowley AT |
| 2027 - 2034 |
Reduction in Energy-Release Rate for Mode-I Fracture of a Fiber with a Cracked Coating Layer Due to Small-Scale Interfacial Debonding
Ochiai S, Hojo M |
| 2035 - 2042 |
Engineered Flux-Pinning Centers in Pb-Doped High-Temperature Superconducting Bi2Sr2Cacu2O8 Ceramics
Majewski P, Su HL, Aldinger F |
| 2043 - 2046 |
Impedance Spectroscopy Studies of Orthorhombic Fenbo4
Tena MA, Garciabelmonte G, Bisquert J, Escribano P, Colomer MT, Jurado JR |
| 2047 - 2050 |
Influence of Deposition Potential and Electrolyte-Composition on the Structural and Photoelectrochemical Properties of Electrodeposited Mercury Cadmium Telluride
Ramiro J, Camarero EG |
| 2051 - 2057 |
The Effects of Heat-Treatment Variables on the Microstructure and Properties of Ultra-High Strength Steels Differing in Titanium Content
Shokuhfar A, Wallphy Z |
| 2059 - 2064 |
Correction to the Fukuda-Kawata Youngs Modulus Theory and the Fukuda-Chou Strength Theory for Short-Fiber-Reinforced Composite-Materials
Jayaraman K, Kortschot MT |
| 2065 - 2069 |
Damage and Fracture of a Cross Woven C/SiC Composite Subject to Compression Loading
Wang MD, Laird C |
| 2071 - 2080 |
Fatigue Behavior in a Plastic Strain-Controlled Mode of an Austenitic Stainless-Steel Treated by Explosive
Gerland M, Dufour JP, Fouillandpaille L, Violan P, Presles HN, Mendez J |
| 2081 - 2089 |
Linear and Nonlinear Conductive Spectra of Polyethylene Oxide/Salt Complex
Tajitsu Y |
| 2091 - 2095 |
Influence of Ferrite-Martensite Microstructural Morphology on Tensile Properties of Dual-Phase Steel
Sarwar M, Priestner R |
| 2097 - 2108 |
Behavior of Hastelloy-C22 Steel in Sulfate-Solutions at pH-3 and Low-Temperatures
Bellanger G, Rameau JJ |
| 2109 - 2116 |
Adhesion of Nylon-6 on Surface-Treated Aluminum Substrates
Wan KT, Diprima A, Ye L, Mai YW |
| 2117 - 2122 |
Nickel Aluminide (Ni3Al) Fabricated by Reactive Infiltration
Chen YY, Chung DD |
| 2123 - 2130 |
Surface-State Improvement of Ground at and SC Quartz Cuts by Controlled Dissolution in NaOH, KOH, Lioh
Deleuze M, Goiffon A, Ibanez A, Philippot E |
| 2131 - 2138 |
Thermal-Shock Behavior of a Coarse-Grain Porous Alumina .1. Temperature-Field Determination
Mignard F, Olagnon C, Fantozzi G, Chantrenne P, Raynaud M |
| 2139 - 2143 |
Microstructural Characterization of a Rapidly-Solidified Al-12 Wt-Percent Si Alloy
Birol Y |
| 2145 - 2148 |
Stress-Affected Transformation to Lower Bainite
Chang LC, Bhadeshia HK |
| 2149 - 2157 |
Inertia-Friction Welding of SiC-Reinforced 8009-Aluminum
Lienert TJ, Baeslack WA, Ringnalda J, Fraser HL |
| 2159 - 2164 |
Incorporation of LiNbO3 Crystals into Tellurite Glasses
Kim HG, Komatsu T, Sato R, Matusita K |
| 2165 - 2170 |
Fabrication of C/SiC Composites by an Electrodeposition/Sintering Method and the Control of the Properties
Kawai C, Wakamatsu S |
| 2171 - 2175 |
The Influence of the Morphotropic Phase-Boundary on the Dielectric and Piezoelectric Properties of the Pnn-Pz-Pt Ternary-System
Zhu XH, Meng ZY |
| 2177 - 2186 |
Dielectric-Relaxation and Electrical-Conduction at Low-Field of Mineral-Filled Epoxy
Wu SL, Tung IC |
| 2187 - 2192 |
Preparation of Porous Nickel Electrodes for Molten-Carbonate Fuel-Cells by Nonaqueous Tape Casting
Antolini E, Ferretti M, Gemme S |
| 2193 - 2198 |
The Tensile Behavior of Gamma-Titanium Aluminide Intermetallic
Srivatsan TS, Strangwood M, Soboyejo WO |
| 2199 - 2205 |
Effect of Sulfate-Ions on the Formation and Physicochemical Properties of Ferric-Oxide Hydroxides Prepared by a Homogeneous Precipitation Method .1.
Parida KM, Das J |
| 2207 - 2212 |
The High-Temperature Thermal-Expansion of Bipbsrcacuo Superconductor and the Oxide Components (Bi2O3, PbO, CaO, CuO)
Dzhafarov TD, Altunbas M, Gorur O |
| 2213 - 2219 |
The Influence of Chemical-Structure on the Friction Properties Between Particles and Compacted Powder Surfaces
Podczeck F, Newton JM, James MB |
