| 227 - 229 |
Some Properties of CaO-MgO-P2O5 Glasses
Sahar MR, Abidin AZ |
| 230 - 233 |
Influence of Load on Abrasion of Fly Ash-Glass Fiber-Reinforced Composites
Chand N, Gautam KK |
| 234 - 235 |
Vinylon-Reinforced Aluminum Laminate
Sui GX, Zhou BL, Zhou CT, Shi CX |
| 236 - 237 |
Stress Measurement as a New Technique for Determining Glass-Transition Temperatures and Other Thermomechanical Properties of Polymers
Gaynor JF, Desu SB |
| 238 - 240 |
A Rapid Technique for Preparing Transmission Electron-Microscopy Samples from Fine Tungsten Wires
Mcgee S, Betrabet HS |
| 241 - 244 |
Effect of Calcination Temperature on the Sb-Doped Bi-Sr-Ca-Cu-O (BSCCO) System
Agnihotry SA, Bhawalkar RH, Chandra RS |
| 245 - 246 |
Biomimetic Design of Interface in Composites
Wang YO, Zhou BL, Wang ZM, Shi CX |
| 247 - 249 |
Preparation of Solid and Hollow Diamond Fibers and the Potential for Diamond Fiber Metal-Matrix Composites
May PW, Rego CA, Thomas RM, Ashfold MN, Rosser KN, Partridge PG, Everitt NM |
| 250 - 252 |
The Morphology in Relation to the Periodic-Table of the Phase Richest in Aluminum in Cast Binary Aluminum-Alloys
Stone HE |
| 253 - 255 |
Dielectric and Conductivity Properties of Lanthanum-Modified Strontium Copper Niobate
Rao KS, Rao PS, Rao KR, Rao AV, Robin AI, Tandon RP |
| 256 - 257 |
Preparation and Magnetic-Properties of Nanocrystalline Life-5O8
Yang H, Song LZ, Wu FQ, Wang ZC, Wang JP, Luo HL |
| 258 - 259 |
Effect of Gelation on Setting Time in Ethyl Silicate-Bonded Investment
Wakasa K, Yoshida Y, Ikeda A, Yamaki M |
| 260 - 262 |
Corrosion Kinetics of Ion-Implanted Fe-Based Alloys in Sulfuric-Acid-Solution
Cai WP, Tian W, Wu R |
| 263 - 265 |
Microhardness Studies of Doped and Undoped Strontium Tartrate Tetrahydrate Single-Crystals
Rethinam FJ, Ramasamy S, Arivuoli D, Ramasamy P |
| 266 - 269 |
Protection of Ferritic Stainless-Steel Against Oxidation by Zirconia Coatings
Atik M, Zarzycki J, Rkha C |
| 270 - 271 |
The Effect of Pore-Size at the Liquid-Solid Interface - The O-2 Quenching of Excited Ru(bpy)3(2+) on Porous-Glass
Yazawa T, Yamamura S, Tatsu Y |
| 272 - 274 |
Control of Youngs Modulus of Carbon-Fiber
Tsai JS, Wu CJ |
| 275 - 279 |
Characterization of High-Area Mgxfe2O3+x (0-Less-Than-or-Equal-to-X-Less-Than-or-Equal-to-2) Mono-Phasic Powders by Vibrational Spectroscopies
Baraton MI, Busca G, Lorenzelli V, Willey RJ |
| 280 - 282 |
Environmental-Effects on the Bondability of O2 Plasma-Treated Polyolefins
Xiao G, Hua BJ, Yang JS, Wang JM |
| 283 - 285 |
Air-Cured Bamboo Pulp Reinforced Cement
Coutts RS, Ni Y, Tobias BC |
| 286 - 288 |
Helium Ion-Irradiated Polyamidoimide Films - A FT-Ir and Raman Follow-Up
Merhari L, Belorgeot C, Quintard P |
| 289 - 290 |
Behavior of Stainless-Steel in Ca(Oh)2 Saturated Solution Containing Chlorides
Pernice P, Aronne A, Muscetta S |
| 291 - 292 |
Toughness and Fracture Surface-Energy of Wet SiO2-SiO2 Sonogel Composites
Zarzycki J, Atik M |
| 293 - 296 |
Microstructure and Properties of AlN Matrix Composites Produced by the Directed Nitridation of Molten Aluminum
Aghajanian MK, Biel JP, Smith RG, Kennedy CR |
| 297 - 300 |
Spectral and Electrical-Properties of 2,6-Dimethylnaphthalene-TCNQ Charge-Transfer Complex
Ayad MM |
