| 327 - 342 |
The potential of model studies for the understanding of catalyst poisoning and temperature effects in polymer electrolyte fuel cell reactions
Behm RJ, Jusys Z |
| 343 - 350 |
Effect of ammonia on the performance of polymer electrolyte membrane fuel cells
Halseid R, Vie PJS, Tunold R |
| 351 - 359 |
Ethanol electro-oxidation on carbon-supported Pt, PtRu and Pt3Sn catalysts: A quantitative DEMS study
Wang H, Jusys Z, Behm RJ |
| 360 - 363 |
Simultaneous electrochemical impedance spectroscopy of single cells in a PEM fuel cell stack
Hakenjos A, Zobel M, Clausnitzer J, Hebling C |
| 364 - 369 |
The effect of the matrix on the electro-catalytic properties of methanol tolerant oxygen reduction catalysts based on ruthenium-chalcogenides
Ozenler SS, Kadirgan F |
| 370 - 378 |
Thermal start-up behaviour and thermal management of SOFC's
Apfel H, Rzepka A, Tu H, Stimming U |
| 379 - 385 |
Diesel fuel processor for PEM fuel cells: Two possible altematives (ATR versus SR)
Cutillo A, Specchia S, Antonini M, Saracco G, Specchia V |
| 386 - 393 |
Dynamic fuel cell models and their application in hardware in the loop simulation
Lemes Z, Vath A, Hartkopf T, Mancher H |
| 394 - 403 |
Dynamic behaviour of SOFC short stacks
Molinelli M, Larrain D, Autissier N, Ihringer R, Sfeir J, Badel N, Bucheli O, Van Herle J |
| 404 - 411 |
Low temperature operation and influence parameters on the cold start ability of portable PEMFCs
Oszcipok M, Zedda M, Riemann D, Geckeler D |
| 412 - 419 |
Dynamic investigation of PEFC stacks in interaction with the air supply system
Philipps F, Simons G, Schiefer K |
| 420 - 427 |
Analysis of dynamic requirements for fuel cell systems for vehicle applications
Pischinger S, Schonfelder C, Ogrzewalla H |
| 428 - 436 |
Efficiency enhancement in gasoline reforming through the recirculation of reformate
Schafer J, Sommer M, Diezinger S, Trimis D, Durst F |
| 437 - 447 |
Influence of cathode opening size and wetting properties of diffusion layers on the performance of air-breathing PEMFCs
Schmitz A, Tranitz M, Eccarius S, Weil A, Hebling C |
| 448 - 455 |
Engineering aspects and hardware verification of a volume producable solid oxide fuel cell stack design for diesel auxiliary power units
Stelter M, Reinert A, Mai BE, Kuznecov M |
| 456 - 460 |
Hydrogen storage in metal-hydrogen systems and their derivatives
Eberle U, Arnold G, von Helmolt R |
| 461 - 466 |
Large stationary fuel cell systems: Status and dynamic requirements
Bischoff M |
| 467 - 471 |
Injection moulding of graphite composite bipolar plates
Muller A, Kauranen P, von Ganski A, Hell B |
| 472 - 478 |
Fuel cells for power generation and waste treatment
Gair S, Cruden A, McDonald J, Hegarty T, Chesshire M |
| 479 - 488 |
Auxiliary power unit based on a solid oxide fuel cell and fuelled with diesel
Lawrence J, Boltze M |
| 489 - 496 |
Dynamic behavior of gasoline fuel cell electric vehicles
Mitchell W, Bowers BJ, Garnier C, Boudjemaa F |
| 497 - 502 |
Fuel cell commercialization: The key to a hydrogen economy
Zegers P |
| 503 - 508 |
Fuel processors for fuel cell APU applications
Aicher T, Lenz B, Gschnell F, Groos U, Federici F, Caprile L, Parodi L |
| 509 - 517 |
VRLA batteries, advances and limitations
Berndt D |
| 518 - 522 |
Current distribution over the electrode surface in a cylindrical VRLA cell during discharge
Krivak P, Baca P, Calabek M, Micka K, Kral P |
| 523 - 529 |
Advanced technologies in VRLA batteries for automotive applications
Ohmae T, Sawai K, Shiomi M, Osumi S |
| 530 - 538 |
Fundamentals of battery dynamics
Jossen A |
| 539 - 544 |
Investigations into a battery management for high power nickel metal hydride batteries
Markolf R, Ohms D, Muller G, Schulz C, Harmel J, Wiesener K |
| 545 - 549 |
Temperature behaviour: Comparison for nine storage technologies -Results from the INVESTIRE Network
Perrin M, Malbranche P, Lemaire-Potteau E, Willer B, Soria ML, Jossen A, Dahlen M, Ruddell A, Cyphelly I, Semrau G, Sauer DU, Sarre G |
| 550 - 555 |
Temperature behavior and impedance fundamentals of supercapacitors
Kotz R, Hahn M, Gallay R |
| 556 - 560 |
Temperature and dynamics problems of ultracapacitors in stationary and mobile applications
Michel H |
| 561 - 566 |
Ultracapacitors for automotive applications
Ashtiani C, Wright R, Hunt G |
