| 4173 - 4173 |
Preface JPS CONAPPICE 2010
Daza L, Chaparro AM |
| 4174 - 4180 |
Synthesis of highly ordered three-dimensional nanostructures and the influence of the temperature on their application as solid oxide fuel cells cathodes
Pinedo R, de Larramendi IR, de Aberasturi DJ, de Muro IG, de Larramendi JIR, Arriortua MI, Rojo T |
| 4181 - 4186 |
Evaluation of the R2RuMnO7 pyrochlores as cathodes in solid-oxide fuel cells
Martinez-Coronado R, Aguadero A, de la Calle C, Fernandez MT, Alonso JA |
| 4187 - 4192 |
Single cell study of electrodeposited cathodic electrodes based on Pt-WO3 for polymer electrolyte fuel cells
Martin AJ, Chaparro AM, Daza L |
| 4193 - 4199 |
Homolytic cleavage C-C bond in the electrooxidation of ethanol and bioethanol
Barroso J, Pierna AR, Blanco TC, Morallon E, Huerta F |
| 4200 - 4208 |
Catalyst layers for proton exchange membrane fuel cells prepared by electrospray deposition on Nation membrane
Chaparro AM, Ferreira-Aparicio P, Folgado MA, Martin AJ, Daza L |
| 4209 - 4217 |
Study of flow channel geometry using current distribution measurement in a high temperature polymer electrolyte membrane fuel cell
Lobato J, Canizares P, Rodrigo MA, Pinar FJ, Ubeda D |
| 4218 - 4225 |
Structural, catalytic/redox and electrical characterization of systems combining Cu-Fe with CeO2 or Ce1-xMxO2-delta (M = Gd or Tb) for direct methane oxidation
Hornes A, Munuera G, Fuerte A, Escudero MJ, Daza L, Martinez-Arias A |
| 4226 - 4235 |
Pt and PtRu electrocatalysts supported on carbon xerogels for direct methanol fuel cells
Alegre C, Calvillo L, Moliner R, Gonzalez-Exposito JA, Guillen-Villafuerte O, Huerta MVM, Pastor E, Lazaro MJ |
| 4236 - 4241 |
Influence of the synthesis method on the properties of Pt catalysts supported on carbon nanocoils for ethanol oxidation
Lazaro MJ, Celorrio V, Calvillo L, Pastor E, Moliner R |
| 4242 - 4250 |
Physico-chemical study of the degradation of membrane-electrode assemblies in a proton exchange membrane fuel cell stack
Ferreira-Aparicio P, Gallardo-Lopez B, Chaparro AM, Daza L |
| 4251 - 4263 |
Development and experimental validation of a dynamic thermal and water distribution model of an open cathode proton exchange membrane fuel cell
Strahl S, Husar A, Serra M |
| 4264 - 4269 |
Non-dimensional analysis of PEM fuel cell phenomena by means of AC impedance measurements
Iranzo A, Munoz M, Pino FJ, Rosa F |
| 4270 - 4276 |
Study of CO2 stability and electrochemical oxygen activation of mixed conductors with low thermal expansion coefficient based on the TbBaCo3ZnO7+delta system
Vert VB, Serra JM |
| 4277 - 4282 |
Design and implementation of LQR/LQG strategies for oxygen stoichiometry control in PEM fuel cells based systems
Niknezhadi A, Allue-Fantova M, Kunusch C, Ocampo-Martinez C |
| 4283 - 4289 |
Influence of CrN-coating thickness on the corrosion resistance behaviour of aluminium-based bipolar plates
Barranco J, Barreras F, Lozano A, Maza M |
| 4290 - 4297 |
Oxygen reduction reaction increased tolerance and fuel cell performance of Pt and RuxSey onto oxide-carbon composites
Timperman L, Gago AS, Alonso-Vante N |
| 4298 - 4305 |
LPV observer design for PEM fuel cell system: Application to fault detection
de Lira S, Puig V, Quevedo J, Husar A |
| 4306 - 4313 |
Scale-up of a high temperature polymer electrolyte membrane fuel cell based on polybenzimidazole
Pinar FJ, Canizares P, Rodrigo MA, Ubeda D, Lobato J |
| 4314 - 4323 |
Ammonium based ionic liquids immobilized in large pore zeolites: Encapsulation procedures and proton conduction performance
Eguizabal A, Lemus J, Urbiztondo M, Moschovi AM, Ntais S, Soler J, Pina MP |
| 4324 - 4331 |
Effect of cobalt incorporation in copper-ceria based anodes for hydrocarbon utilisation in Intermediate Temperature Solid Oxide Fuel Cells
Fuerte A, Valenzuela RX, Escudero MJ, Daza L |
| 4332 - 4336 |
Optimization of La0.6Ca0.4Fe0.8Ni0.2O3-Ce0.8Sm0.2O2 composite cathodes for intermediate-temperature solid oxide fuel cells
Ortiz-Vitoriano N, de Larramendi IR, de Larramendi JIR, Arriortua MI, Rojo T |
| 4337 - 4341 |
Ethanol and CO electro-oxidation with amorphous alloys as electrodes
Blanco TC, Pierna AR, Barroso J |
| 4342 - 4346 |
Deuteration properties of CaNi5-xCux system
Retuerto M, Sanchez-Benitez J, Alonso JA, Leardini F, Ares JR, Fernandez JF, Sanchez C |
| 4347 - 4354 |
A comparison between molten carbonate fuel cells based hybrid systems using air and supercritical carbon dioxide Brayton cycles with state of the art technology
Sanchez D, de Escalona JMM, Chacartegui R, Munoz A, Sanchez T |
| 4355 - 4363 |
Preliminary analysis of compound systems based on high temperature fuel cell, gas turbine and Organic Rankine Cycle
Sanchez D, de Escalona JMM, Monje B, Chacartegui R, Sanchez T |
| 4364 - 4369 |
Influence of calcination temperature and atmosphere preparation parameters on CO-PROX activity of catalysts based on CeO2/CuO inverse configurations
Camara AL, Kubacka A, Schay Z, Koppany Z, Martinez-Arias A |
| 4370 - 4381 |
Hydrogen production with CO2 capture by coupling steam reforming of methane and chemical-looping combustion: Use of an iron-based waste product as oxygen carrier burning a PSA tail gas
Ortiz M, Gayan P, de Diego LF, Garcia-Labiano F, Abad A, Pans MA, Adanez J |
| 4382 - 4387 |
CuO/CeO2 supported on Zr doped SBA-15 as catalysts for preferential CO oxidation (CO-PROX)
Reyes-Carmona A, Arango-Diaz A, Moretti E, Talon A, Storaro L, Lenarda M, Jimenez-Lopez A, Rodriguez-Castellon E |
| 4388 - 4395 |
Optimized hydrogen generation in a semicontinuous sodium borohydride hydrolysis reactor for a 60W-scale fuel cell stack
Arzac GM, Fernandez A, Justo A, Sarmiento B, Jimenez MA, Jimenez MM |
| 4396 - 4403 |
Electrochemical characterisation of solid oxide cell electrodes for hydrogen production
Bernuy-Lopez C, Knibbe R, He ZM, Mao XJ, Hauch A, Nielsen KA |
| 4404 - 4410 |
Biogas reforming on La-promoted NiMgAl catalysts derived from hydrotalcite-like precursors
Serrano-Lotina A, Rodriguez L, Munoz G, Daza L |
| 4411 - 4417 |
Controllability study of an ethanol steam reforming process for hydrogen production
Garcia VM, Serra M, Llorca J |
| 4418 - 4426 |
Influence of wind turbine power curve and electrolyzer operating temperature on hydrogen production in wind-hydrogen systems
Pino FJ, Valverde L, Rosa F |
