| 1 - 1 |
In dedication to Professor Garth L. Wilkes
[Anonymous] |
| 2 - 3 |
Introduction for polymer special issue: Advanced polymers for 3D printing/additive manufacturing
Long TE, Williams CB, Bortner MJ |
| 4 - 8 |
Additive manufacturing with a flex activated mechanophore for nondestructive assessment of mechanochemical reactivity in complex object geometries
Cao B, Boechler N, Boydston AJ |
| 9 - 17 |
A hydrophilic coumarin-based polyester for ambient-temperature initiator-free 3D printing: Chemistry, rheology and interface formation
Govindarajan SR, Jain T, Choi JW, Joy A, Isayeva I, Vorvolakos K |
| 18 - 24 |
Solvent-cast 3D printing of polysulfone and polyaniline composites
Miao ZY, Seo J, Hickner MA |
| 25 - 34 |
Functional siloxanes with photo-activated, simultaneous chain extension and crosslinking for lithography-based 3D printing
Sirrine JM, Meenakshisundaram V, Moon NG, Scott PJ, Mondschein RJ, Weiseman TF, Williams CB, Long TE |
| 35 - 41 |
Interlayer diffusion of surface segregating additives to improve the isotropy of fused deposition modeling products
Levenhagen NP, Dadmun MD |
| 42 - 50 |
Chemical modification and printability of shear-thinning hydrogel inks for direct-write 3D printing
Smith PT, Basu A, Saha A, Nelson A |
| 51 - 61 |
Model analysis of feedstock behavior in fused filament fabrication: Enabling rapid materials screening
Gilmer EL, Miller D, Chatham CA, Zawaski C, Fallon JJ, Pekkanen A, Long TE, Williams CB, Bortner MJ |
| 62 - 71 |
Insights into the mechanical properties of several triply periodic minimal surface lattice structures made by polymer additive manufacturing
Maskery I, Sturm L, Aremu AO, Panesar A, Williams CB, Tuck CJ, Wildman RD, Ashcroft IA, Hague RJM |
