Powder Technology

Powder Technology, Vol.234 Entire volume, number list

ISSN: 0032-5910 (Print)

In this Issue (18 articles)

1 - 6	Study of clogging and cleaning cycles of a pleated cartridge filter used in a thermal spraying process to filter ultrafine particles Bemer D, Regnier R, Morele Y, Grippari F, Appert-collin JC, Thomas D
7 - 12	The effect of Mg content on microstructure and mechanical properties of Al-xMg/5Al(2)O(3) nanocomposite prepared by mechanical alloying Safari J, Chermahini MD, Akbari GH
13 - 18	Investigation of structural, microstructural and magnetic properties of mechanically alloyed nanostructured (Fe50Co50)(100-x)Mo-x(x=25,35) powders Tavakoli M, Shokrollahi H, Karimi L, Janghorban K
19 - 25	Adding fly ash microsphere to improve packing density, flowability and strength of cement paste Kwan AKH, Chen JJ
26 - 31	Rapid fabrication of nanostructured magnesium hydroxide and hydromagnesite via microwave-assisted technique Beall GW, Duraia ESM, El-Tantawy F, Al-Hazmi F, Al-Ghamdi AA
32 - 36	Cascade of granular flows for characterizing segregation Lumay G, Boschini F, Cloots R, Vandewalle N
37 - 45	The effect of the particle aspect ratio on the pressure at the bottom of sandpiles Zhu JY, Liang YY, Zhou YH
46 - 57	Investigation of highly laden particle jet dispersion by the use of a high-speed camera and parameter-independent image analysis Puttinger S, Holzinger G, Pirker S
58 - 66	Numerical simulation on the mixing behavior of corn-shaped particles in a spouted bed Ren B, Zhong WQ, Jin BS, Shao YJ, Yuan ZL
67 - 75	Experimental flow behaviors of irregular particles with silica sand in solid waste fluidized bed Shao YJ, Ren B, Jin BS, Zhong WQ, Hu H, Chen X, Sha CF
76 - 83	Activated carbon powders from wool fibers Chen W, Liu X, He RL, Lin T, Zeng QF, Wang XG
84 - 90	Mass production of Al2O3 and ZrO2 nanoparticles by hot-air spray pyrolysis Manivasakan P, Karthik A, Rajendran V
91 - 96	Effect of operational parameters and stress energies on the particle size distribution of TiO2 pigment in stirred media milling Ohenoja K, Illikainen M, Niinimaki J
97 - 106	Hydrodynamics of cold-rig biomass gasifier using semi-dual fluidized-bed Ngo SI, Lim YI, Song BH, Lee UD, Yang CW, Choi YT, Song JH
107 - 116	Modeling the discharge characteristics of rectangular flights in a flighted rotary drum Sunkara KR, Herz F, Specht E, Mellmann J, Erpelding R
117 - 122	Pressure assisted master sintering surface of Co, Cu and Fe powder mixture An K
123 - 131	Novel aspects on the segregation in quasi 2D piles Benito JG, Ippolito I, Vidales AM
132 - 140	Influence of dry and wet ball milling on dispersion characteristics of the multi-walled carbon nanotubes in aqueous solution with and without surfactant Munkhbayar B, Nine MJ, Jeoun J, Bat-Erdene M, Chung H, Jeong H