Powder Technology

Powder Technology, Vol.182, No.3 Entire volume, number list

ISSN: 0032-5910 (Print)

In this Issue (20 articles)

323 - 333	Self-fluidization of subaerial rapid granular flows Bareschino P, Lirer L, Marzocchella A, Petrosino P, Salatino P
334 - 341	Solids mixing behavior in a nano-agglomerate fluidized bed Huang C, Wang Y, Wei F
342 - 353	Drag of non-spherical solid particles of regular and irregular shape Loth E
354 - 363	Effect of albumin on physical characteristics of drug particles produced by supercritical fluid technology Kim YH, Sioutas C, Fine P, Shing KS
364 - 367	A method for disentangling beta-Si3N4 seeds obtained by SHS Belmonte M, Miranzo P, Osendi MI
368 - 378	Characterization of continuous convective powder mixing processes Portillo PM, Ierapetritou MG, Muzzio FJ
379 - 387	Improvement of continuous solid circulation rate measurement in a cold flow circulating fluidized bed Ludlow JC, Monazam ER, Shadle LJ
388 - 397	Characterisation of inter-particle forces within agglomerated metallurgical powders Debrincat DP, Solnordal CB, Van Deventer JSJ
398 - 405	Effect of inclination on gas-fluidized beds of fine cohesive powders Valverde JM, Castellanos A, Quintanilla MAS, Gilabert FA
406 - 414	Exit effect on hydrodynamics of the internal circulating fluidized bed riser Mabrouk R, Chaouki J, Guy C
415 - 423	Assessment of the mixing efficiency of solid mixtures by means of image analysis Daumann B, Nirschl H
424 - 435	On the physical interpretation of the Kawakita and Adams parameters derived from confined compression of granular solids Nordstrom J, Welch K, Frenning G, Alderborn G
436 - 443	Effect of water content on thermal and dynamic mechanical properties of xanthan powder: A comparison between standard and novel techniques Raschip IE, Yakimets I, Martin CP, Paes SS, Vasile C, Mitchell JR
444 - 452	Studies on the influence of a flotation collector reagent on iron ore green pellet properties Forsmo SPE, Forsmo SE, Bjoerkman BMT, Samskog PO
453 - 458	Detection of the minimum gas velocity region using Gaussian spectral pressure distribution in a gas-solid fluidized bed Parise MR, Taranto OP, Kurka PRG, Benetti LB
459 - 465	Preparation of griseofulvin microparticles by supercritical fluid expansion depressurization process Li ZY, Jiang JZ, Liu XW, Zhao SX, Xia YJ, Wang J
466 - 473	Flow of granular material through an inclined, rotating cylinder fitted with a dam Scott DM, Davidson JF, Lim SY, Spurling RJ
474 - 479	CH4-CO2 reforming over Ni/Al2O3 aerogel catalysts in a fluidized bed reactor Hao ZG, Zhu QS, Lei Z, Li HZ
480 - 485	Physical characterization of lansoprazole/PVP solid dispersion prepared by fluid-bed coating technique Zhang XW, Sun NY, Wu BJ, Lu Y, Guan TZ, Wu W
486 - 492	Note on the interpretation of powder shear test data Hilden J, Bowman K, Morris K, Wang S, Sprockel O, Ennis B