Advanced Powder Technology

Advanced Powder Technology, Vol.28, No.1 Entire volume, number list

ISSN: 0921-8831 (Print)

In this Issue (35 articles)

1 - 2	Preface of Special Issue: AMPT2015 Milosevic O, Naito M, Rabanal ME
3 - 22	The processing of optically active functional hierarchical nanoparticles Mancic L, Nikolic M, Gomez L, Rabanal ME, Milosevic O
23 - 29	Characterization and sensing properties of ZnO film prepared by single source chemical vapor deposition Escalante G, Juarez H, Fernandez P
30 - 36	SiO2 nanoparticles surface modified with polyethyleneimine-oleic acid complex as stabilizers of Ni fine particles in dense nonaqueous suspensions Morita S, Iijima M, Tatami J
37 - 42	Spark plasma sintering of silicon nitride using nanocomposite particles Jeong K, Tatami J, Lijima M, Nishimura T
43 - 49	A continuous process for the ultrasonic spray pyrolysis synthesis of RuO2/TiO2 particles and their application as a coating of activated titanium anode Kosevic M, Stopic S, Bulan A, Kintrup J, Weber R, Stevanovic J, Panic V, Friedrich B
50 - 54	Effect of BaF2 powder addition on the synthesis of YAG phosphor by mechanical method Kanai K, Fukui Y, Kozawa T, Kondo A, Naito M
55 - 60	Size-controlled hydrothermal synthesis of monodispersed BaZrO3 sphere particles by seeding Kanie K, Seino Y, Matsubara M, Muramatsu A
61 - 72	Atomic scale study of the dehydration/structural transformation in micro and nanostructured brucite (Mg(OH)(2)) particles: Influence of the hydrothermal synthesis conditions Gomez-Villalba LS, Sierra-Fernandez A, Milosevic O, Fort R, Rabanal ME
73 - 82	Compositional and structural dependence of up-converting rare earth fluorides obtained through EDTA assisted hydro/solvothermal synthesis Dinic IZ, Mancic LT, Rabanal M, Yamamoto K, Ohara S, Tamura S, Koji T, Costa AMLM, Marinkovic BA, Milosevic OB
83 - 92	Solvothermal synthesis of Ag/ZnO microinanostructures with different precursors for advanced photocatalytic applications Munoz-Fernandez L, Sierra-Fernandez A, Flores-Carrasco G, Milosevic O, Rabanal ME
93 - 100	Structural and functional properties of ZnO thin films grown on Si substrates by air assisted USP method from non-aqueous solutions at low-temperature Flores-Carrasco G, Munoz-Fernandez L, Alcantara-Iniesta S, Soto-Cruz BS, Milosevic O, Rabanal ME
101 - 114	Contact properties determination of macroscopic fine disperse glass particles via compression tests in normal direction Mader-Arndt K, Aman S, Fuchs R, Tomas J
115 - 121	Consideration of the stress dependence of the bulk density in silo storage of dusts from dry off-gas cleaning Lanzerstorfer C
122 - 130	A novel green synthesis of zero valent iron nanoparticles (NZVI) using three plant extracts and their efficient application for removal of Cr(VI) from aqueous solutions Fazlzadeh M, Rahmani K, Zarei A, Abdoallahzadeh H, Nasiri F, Khosravi R
131 - 138	Characterizations of nanostructured nickel aluminates as catalysts for conversion of glycerol: Influence of the preparation methods Neto ASB, Oliveira AC, Filho JM, Amadeo N, Dieuzeide ML, de Sousa FF, Oliveira AC
139 - 145	Stabilization of SnO2 nanoparticles into the nanopores of modified Montmorillonite and their antibacterial activity Phukan A, Bhattacharjee RP, Dutta DK
146 - 154	Molten-salt synthesis of tetragonal micron-sized barium titanate from a peroxo-hydroxide precursor Ozen M, Mertens M, Snijkers F, D'Hondt H, Cool P
155 - 166	Experimental and numerical study of cylindrical triaxial test on mono-sized glass beads under quasi-static loading condition Wu K, Pizette P, Becquart F, Remond S, Abriak N, Xu WY, Liu SY
167 - 176	CFD modelling of moisture evaporation in an industrial dispersed system Wawrzyniak P, Jaskulski M, Zbicinski I, Podyma M
177 - 184	Synthesis of hexagonal plate-like Al4Si2C5 and the effect of Al4Si2C5 addition to Al2O3-C refractory Yu C, Deng CJ, Zhu HX, Xue ZL, Ding J, Zhou SM
185 - 196	Dependencies between internal structure and mechanical properties of spray dried granules - Experimental study and DEM simulation Eckhard S, Fries M, Antonyuk S, Heinrich S
197 - 214	Density maximum effects on mixed convection in a square lid-driven enclosure filled with Cu-water nanofluids Mastiani M, Kim MM, Nematollahi A
215 - 222	High strength geopolymer binder based on waste-glass powder Vafaei M, Allahverdi A
223 - 229	Solid state amorphization of Mg-Zn-Ca system via mechanical alloying and characterization Manne B, Bontha S, Ramesh MR, Krishna M, Balla VK
230 - 235	CeO2-Cu2O composite nanofibers: Synthesis, characterization photocatalytic and electrochemical application Chae BW, Amna T, Hassan MS, Al-Deyab SS, Khil MS
236 - 243	A detailed investigation of the microwave assisted phenylphosphonic acid modification of P25 TiO2 Tassi M, Roevens A, Reekmans G, Vanhamel M, Meynen V, D'Haen J, Adriaensens P, Carleer R
244 - 255	Entropy generation due to natural convection of a nanofluid in a partially open triangular cavity Bondareva NS, Sheremet MA, Oztop HF, Abu-Hamdeh N
256 - 265	Numerical investigation of nanofluid heat transfer in helically coiled tubes using the four-equation model Bagherzadeh F, Saffar-Avval M, Seyfi M, Abbassi A
266 - 279	Chemical surface modification of aluminum oxide nanoparticles with graft copolymer of aluminum oxide and poly(isobutyl vinyl ether) mechanochemically synthesized in vacuum at low temperature Motokawa T, Makino M, Yamamoto K, Takase H, Nagano S, Enomoto-Rogers Y, Iwata T, Kawaguchi T, Sakaguchi M
280 - 287	Effect of adsorption behaviour of polyelectrolytes on fluidity and packing ability of aqueous graphite slurries Mori T, Kitamura K
288 - 298	Magnetohydrodynamic (MHD) stratified bioconvective flow of nanofluid due to gyrotactic microorganisms Alsaedi A, Khan MI, Farooq M, Gull N, Hayat T
299 - 303	Synthesis of dispersed PrBaCo0.9Cu0.1O5+delta cathode nanopowders with layered perovskite structure for intermediate temperature solid oxide fuel cells Ryu J
304 - 313	Enhancement of photocatalytic activity and stability of Ag2CO3 by formation of AgBr/Ag2CO3 heterojunction in mordenite zeolite Asadollahi A, Sohrabnezhad S, Ansari R
314 - 323	Titanium aluminide (Ti-48Al) powder synthesis, size refinement and sintering Liu HW, Plucknett KP