3 - 3 |
A look back - Ready for a new one Bock B |
13 - 22 |
Virtual Modeling of products with a centrifugal pump impeller as an example Benra FK, Kohler P, Witt G |
25 - 35 |
Endurance limit of ground and TIG dressed steel welded joints under proportional loading Rudolph J |
36 - 41 |
Measurement of sorption isotherms and diffusion coefficients in polymer solutions Schabel W, Mamaliga I, Kind M |
41 - 52 |
Coupling of CFD and process simulation for industrial design of cracking furnaces for olefin plant Mobus H, Kaufmann D |
52 - 57 |
Simulation of compressible pulsating flow in compressor piping systems with the PURO2002 simulation system Stehr H |
58 - 62 |
Prediction of thermodynamic material properties with the COSMO-RS continuum model Spuhl O, Arlt W, Hernandez AD |
62 - 68 |
Modeling of droplet populations - Influence of material systems and technical geometries Schmidt SA, Simon M, Bart HJ |
68 - 72 |
Compact reactor concept for autothermal steam reforming with integrated evaporation and shift stage Morillo A, Merten C, Eigenberger G, Hermann I, Lemken D |
72 - 76 |
Removal of nitrogen oxides by the NH3-SCR process: Catalysts based on industrial residues containing iron(III) oxide Weisweiler W, Mallonn E, Gorke O |
76 - 80 |
Influence of solids discharge geometry on separation in a gas cyclone at high temperature Obermair S, Bohnet M, Staudinger G |
82 - 86 |
Empirical studies on unstable filter operation Leubner H, Riebel U |
86 - 90 |
Microwave desorption in a vacuum Richrath M, Borren T, Bathen D, Schmidt-Traub H |
90 - 94 |
Kinetics of the reaction of CO2 and OH--ions at infinite dilution Kucka L, Richter J, Kenig EY, Gorak A |
94 - 97 |
Simultaneous measurement of gas velocity and oxygen concentration in firing systems Zimmel M, Staudinger G, Schotte E, Rau H |
97 - 100 |
pH glass sensors in photo-structured fluidics components Kaden H, Herrmann S |
101 - 104 |
Limiting oxygen concentrations of combustible gases and vapors Fuss O, Molnarne M, Schonbucher A, Schroder V |
104 - 108 |
Time- and velocity-dependent behavior of bulk solids as condition for slip-stick Schulze D |
108 - 112 |
Introduction of cyclic amidines into nitrile-containing polymers in the melt Becker HG, Schmidt-Naake G |
131 - 135 |
Development of a novel jetstream membrane reactor for cell culturing by means of CFD Bohlmann JT |
136 - 139 |
Enzymatically catalyzed synthesis of galactosyl-oligosaccharides in a continuous membrane reactor system Czermak P, Ebrahimi M, Grau K, Netz S, Sawatzki G |
139 - 142 |
Mathematical modeling of the single-cell microalge Porphyridium pupureum Fleck P, Posten C |
142 - 146 |
High-pressure liquid/liquid extraction in the presence of almost-critical carbon dioxide Freitag J, Tuma D, Maurer G |
146 - 149 |
Recovery and characterization of a L-serine dehydratase from the marine bacterium Paracoccus seriniphilus for the construction of bioanalytical systems Laroche M, Pukall R, Ulber R |
149 - 153 |
Molecularly imprinted nanoparticles as selective phase in composite membranes: Hydrodynamics and separation in nanoscale beds Lehmann M, Brunner H, Tovar GEM |
154 - 160 |
Ecological comparison of combustion and rectification of waste solvents Hofstetter TB, Capello C, Hungerbuhler K |