1 - 11 |
Experimental investigation of the solar FPC performance using graphene oxide nanofluid under forced circulation Vincely DA, Natarajan E |
12 - 20 |
Design of a SOFC/GT/SCs hybrid power system to supply a rural isolated microgrid Camblong H, Baudoin S, Vechiu I, Etxeberria A |
21 - 30 |
Effect of water-containing acetone-butanol-ethanol gasoline blends on combustion, performance, and emissions characteristics of a spark-ignition engine Li YQ, Nithyanandan K, Lee TH, Donahue RM, Lin YL, Lee CF, Liao SM |
31 - 42 |
Thermodynamic analysis of single-stage and multi-stage adsorption refrigeration cycles with activated carbon-ammonia working pair Xu SZ, Wang LW, Wang RZ |
43 - 53 |
Effect of process parameters on solvolysis liquefaction of Chlorella pyrenoidosa in ethanol-water system and energy evaluation Peng XW, Ma XQ, Lin YS, Wang XS, Zhang XS, Yang C |
54 - 62 |
Cultivation and harvesting of microalgae in photobioreactor for biodiesel production and simultaneous nutrient removal Yang IS, Salama ES, Kim JO, Govindwar SP, Kurade MB, Lee M, Roh HS, Jeon BH |
63 - 73 |
Design considerations and construction of an experimental prototype of concentrating solar power tower system in Saudi Arabia Abu-Hamdeh NH, Alnefaie KA |
74 - 85 |
A numerical study on the effects of exhaust locations on energy consumption and thermal environment in an office room served by displacement ventilation Ahmed AQ, Gao SA, Kareem AK |
86 - 94 |
Effect of diesel pre-injection timing on combustion and emission characteristics of compression ignited natural gas engine Xu M, Cheng W, Zhang HF, An T, Zhang SH |
95 - 105 |
Exergoeconomic multi objective optimization and sensitivity analysis of a regenerative Brayton cycle Naserian MM, Farahat S, Sarhaddi F |
106 - 114 |
Use of carbon dioxide as a reaction medium in the thermo-chemical process for the enhanced generation of syngas and tuning adsorption ability of biochar Cho DW, Kwon EE, Song H |
115 - 131 |
Numerical investigation of frictional behavior and energy loss in mixed-hydrodynamic contact of piston ring pack with deformed cylinder liner during warm-up period of SI-engine Usman A, Park CW |
132 - 141 |
Thermal energy storage characteristics of bentonite-based composite PCMs with enhanced thermal conductivity as novel thermal storage building materials San A |
142 - 149 |
Open-loop solar tracking strategy for high concentrating photovoltaic systems using variable tracking frequency Mi Z, Chen JK, Chen NF, Bai YM, Fu R, Liu H |
150 - 161 |
A comparative thermodynamic investigation with environmental analysis of SOFC waste heat to power conversion employing Kalina and Organic Rankine Cycles Gholamian E, Zare V |
162 - 170 |
Integrated process for synthetic natural gas production from coal and coke-oven gas with high energy efficiency and low emission Man Y, Yang SY, Qian Y |
171 - 184 |
Experimental and lattice Boltzmann simulated operation of a copper micro-channel heat exchanger Borquist E, Thapa S, Weiss L |
185 - 192 |
Microemulsion based hybrid biofuels using glycerol monooleate Bora P, Konwar LJ, Deka D |
193 - 205 |
Adsorption assisted double stage cooling and desalination employing silica gel plus water and AQSOA-Z02+water systems Ali SM, Chakraborty A |
206 - 217 |
Novel investigation of the different Omni-direction-guide-vane angles effects on the urban vertical axis wind turbine output power via three-dimensional numerical simulation Shahizare B, Nik-Ghazali N, Chong WT, Tabatabaeikia S, Izadyar N, Esmaeilzadeh A |
218 - 227 |
A theoretical analysis of the impact of atmospheric parameters on the spectral, electrical and thermal performance of a concentrating III-V triple-junction solar cell Theristis M, Fernandez EF, Stark C, O'Donovan TS |
228 - 240 |
Thermo-economic analysis of proton exchange membrane fuel cell fuelled with methanol and methane Suleiman B, Abdulkareem AS, Musa U, Mohammed IA, Olutoye MA, Abdullahi YI |
241 - 250 |
Thermodynamic analysis of a solar-hybrid trigeneration system integrated with methane chemical-looping combustion Wang JJ, Fu C |
251 - 263 |
Thermodynamic analysis of CO2 capture by calcium looping process driven by coal and concentrated solar power Zhai RR, Li C, Qi JW, Yang YP |
264 - 272 |
Optimization of oil extraction from waste "Date pits" for biodiesel production Jamil F, Al-Muhtaseb AH, Al-Haj L, Al-Hinai MA, Hellier P, Rashid U |
273 - 280 |
A critical comparison of pyrolysis of cellulose, lignin, and pine sawdust using an induction heating reactor Muley PD, Henkel C, Abdollahi KK, Marculescu C, Boldor D |
281 - 288 |
A Thermorisk framework for the analysis of energy systems by combining risk and exergy analysis Cassetti G, Colombo E, Zio E |
289 - 296 |
SOFC regulation at constant temperature: Experimental test and data regression study Barelli L, Bidini G, Cinti G, Ottaviano A |
297 - 304 |
Physicochemical characterization of typical municipal solid wastes for fermentative hydrogen and methane co-production Cheng J, Ding LK, Lin RC, Liu M, Zhou JH, Cen KF |
305 - 318 |
Investigating a conventional and retrofit power plant on-board a Roll-on/Roll-off cargo ship from a sustainability perspective - A life cycle assessment case study Ling-Chin J, Roskilly AP |
319 - 325 |
Hydrated calcined Cyrtopleura costata seashells as an effective solid catalyst for microwave-assisted preparation of palm oil biodiesel Marwan, Indarti E |
326 - 334 |
Co-pyrolysis of microalgae and sewage sludge: Biocrude assessment and char yield prediction Wang X, Zhao BW, Yang XY |
335 - 342 |
Thermodynamic analysis of a new combined cooling and power system using ammonia-water mixture Wang JF, Wang JY, Zhao P, Dai YP |
343 - 350 |
Biomass to hydrogen-rich syngas via steam gasification of bio-oil/biochar slurry over LaCo1-xCuxO3 perovskite-type catalysts Yao JG, Liu J, Hofbauer H, Chen GY, Yan BB, Shan R, Li WQ |
351 - 366 |
Coupled on-site measurement/CFD based approach for high-resolution wind resource assessment over complex terrains Yan BW, Li QS |
367 - 374 |
Investigation on the co-combustion of oil shale and municipal solid waste by using thermogravimetric analysis Fan YL, Yu ZS, Fang SW, Lin Y, Lin YS, Liao YF, Ma XQ |
375 - 392 |
Comparison of desiccant air conditioning systems with different indirect evaporative air coolers Pandelidis D, Anisimov S, Worek WM, Drag P |
393 - 399 |
Experimental study on gasification performance of bamboo and PE from municipal solid waste in a bench-scale fixed bed reactor Zheng XY, Chen C, Ying Z, Wang B |
400 - 409 |
Scrutinizing the combustion, performance and emissions of safflower biodiesel-kerosene fueled diesel engine used as power source for a generator Aydin H |
410 - 419 |
Effects of fatty acid methyl esters proportion on combustion and emission characteristics of a biodiesel fueled diesel engine Jiaqiang E, Liu T, Yang WM, Li J, Gong JK, Deng YW |
420 - 430 |
A holistic method for selecting tidal stream energy hotspots under technical, economic and functional constraints Vazquez A, Iglesias G |
431 - 441 |
Development and investigation of a non-catalytic self-aspirating meso-scale premixed burner integrated thermoelectric power generator Singh T, Marsh R, Min G |
442 - 453 |
Exergoeconomic and environmental analyses of CO2/NH3 cascade refrigeration systems equipped with different types of flash tank intercoolers Mosaffa AH, Farshi LG, Ferreira CAI, Rosen MA |
454 - 465 |
Energy, economy, and environment analysis and optimization on manufacturing plant energy supply system Feng LJ, Mears L, Beaufort C, Schulte J |
466 - 474 |
An assessment on performance, emission and combustion characteristics of single cylinder diesel engine powered by Cymbopogon flexuosus biofuel Dhinesh B, Lalvani JIJ, Parthasarathy M, Annamalai K |
475 - 481 |
Metal foams as gas coolers for exhaust gas recirculation systems subjected to particulate fouling Hooman K, Malayeri MR |
482 - 489 |
Configuration parameters design and optimization for plate-fin heat exchangers with serrated fin by multi-objective genetic algorithm Wen J, Yang HZ, Tong X, Li K, Wang SM, Li YZ |
490 - 500 |
Experimental analysis and performance evaluation of a tandem photovoltaic-thermoelectric hybrid system Kossyvakis DN, Voutsinas GD, Hristoforou EV |
501 - 512 |
An integrated multi attribute decision model for energy efficiency processes in petrochemical industry applying fuzzy set theory Taylan O, Kaya D, Demirbas A |
513 - 519 |
Experimental study on steam gasification of coal using molten blast furnace slag as heat carrier for producing hydrogen-enriched syngas Duan WJ, Yu QB, Wu TW, Yang F, Qin Q |
520 - 527 |
Catalytic performance and durability of Ni/AC for HI decomposition in sulfur-iodine thermochemical cycle, for hydrogen production Fu GS, He Y, Zhang YW, Zhu YQ, Wang ZH, Cen KF |
528 - 537 |
Hydrogen production from lignin, cellulose and waste biomass via supercritical water gasification: Catalyst activity and process optimization study Kang K, Azargohar R, Dalai AK, Wang H |
538 - 547 |
Effect of VS organic loads and buckwheat husk on methane production by anaerobic co-digestion of primary sludge and wheat straw Elsayed M, Andres Y, Blel W, Gad A, Ahmed A |
548 - 557 |
Performance, emissions and lubricant oil analysis of diesel engine running on emulsion fuel Hasannuddin AK, Wira JY, Sarah S, Aqma WMNWS, Hadi ARA, Hirofumi N, Aizam SA, Aiman MAB, Watanabe S, Ahmad MI, Azrin MA |
558 - 566 |
Pyrolysis oil upgrading using supercritical water, with tetralin and 1-methylnaphtalene as a baseline study Isa KM |
567 - 576 |
Experimental study of thermodynamic assessment of a small scale solar thermal system Helvaci HU, Khan ZA |
577 - 585 |
Thermal management of Li-ion battery with liquid metal Yang XH, Tan SC, Liu J |