Cleat orientation, cleat frequency and cleat angle distribution of deep coal seams are only available by the use of drilling cores and from coal mine samples. Coal drilling cuttings are a cheap and fast alternative to measure cleat angle distributions with the use of image analysis techniques. In this study oriented coal samples and drilling cuttings of the RECOPOL field experiment are compared and used to explain and validate the proposed method. In other words, cleat angle distributions from drilling cuttings are measured by image analysis. The geological framework of the polish coals is described. The image analysis methodologies for the measurement of fracture faces of cuttings and from CT-scan images, derived from these coals, are explained. The results of the methods on the cuttings are compared with cleat orientation distributions from CT-scans and artificial fragments from coal blocks of the same seams. These evaluations show high agreements between the methods. The cleat angle distributions of drilling cuttings of four seams are compared with the cleat orientation distributions of a regional structural geological study. The high correlation in this study shows that cleat angle distributions of coal seams can be used as input parameters for reservoir modelling. (c) 2007 Elsevier B.V. All rights reserved.