This work describes a laboratory study concerning the adsorption of isopropylxanthate ions onto modified zeolites particles. The separation of the loaded carrier and their removal, from aqueous solutions, was conducted by flocculation followed by dissolved air flotation, DAF. The zeolite employed was a natural sample (approximately 48% clinoptilolite and 30% mordenite) which was previously treated with sodium ions (activation) and modified with copper ions (Cu-Z) before the xanthate ions uptake. Adsorption capacities (q(m)) for Cu-Z were 0.34 meq g(-1) for the powdered form, and 1.12 meq g(-1) for the floc form. The adsorption capacity for the floc form appears to involve an enhanced electrostatic adsorption due to the positive sites on the floc surface. in all cases, the isopropylxanthate concentration in the treated water was found to be negligible (<0.04 mg L(-1)). The flotation technique showed to be a fast process, requires a low recycle ratio (20%) in air saturated water, and the treated water ended up with a very low residual turbidity (6.8 NTU). It is believed that this adsorption-flotation technique, here named adsorptive particulate flotation. using activated and modified natural zeolite has a high potential as an alternative for pollutants removal (copper and isopropylxanthate ions) from waste mining effluents. (C) 2008 Published by Elsevier B.V.