For developing functional biomaterials, an understanding of the biological response at material surfaces is of key importance. In particular, surface chemistry, roughness and cell type influence this response. Many previous reports in the literature have involved the study of single cell types and their adhesion to surfaces with a limited range of water contact angles. The objective of this study was to investigate the adhesion of five cell lines on surfaces with contact angles in the range of 20 degrees to 115 degrees. This range of water contact angles was obtained using siloxane and fluorosiloxane coatings deposited using atmospheric plasma deposition. These nm thick coatings were deposited by nebulizing liquid precursors consisting of poly(dimethylsiloxane) (PDMS) and a mixture of perfluorodecyl acrylate/tetraethylorthosilicate (PPFDA/TEOS) into the atmospheric plasmas. Cell adhesion studies were carried out with the following cell types: Osteoblast, Human Embryonic Kidney (HEK), Chinese hamster ovary (CHO), Hepatocytes (HepZ) and THP1 leukemic cells. The study demonstrated that cell adhesion was significantly influenced by the type of cell line, water contact angle and coating chemistry. For example, the sensitivity of cell lines to changes in contact angle was found to decrease in the following order: Osteoblasts > Hepatocytes > CHO. The HEK and THP-1 inflammatory cells in contrast were not found to be sensitive to changes in water contact angle. (C) Koninklijke Brill NV, Leiden, 2010