Measurements of the surface tension (gamma(LV)) and advancing contact angle (theta) on poly(tetrafluoroethylene) (PTFE) and poly(methyl methacrylate) (PMMA) were carried out for aqueous solutions of sodium decyl sulfate (SDS) and p-(1,1,3,3-tetramethylbutyl)phenoxypoly(ethylene glycol) (TX100) and their mixtures. The results obtained indicate that the values of the surface tension and contact angles of solutions of surfactants on PTFE and PMMA surfaces depend on the concentration and composition of the surfactant mixtures. Calculations based on the Lucassen-Reynders equation indicate that for single surfactants and their mixtures at a given concentration in the bulk phase the values of surface excess concentration of surfactants at water-air and PTFE-water interfaces are nearly the same, so the adsorption of the surfactants at water-air and PTFE-water interfaces should also be the same. However, the adsorption of TX100 and its mixtures with SDS at water-air interface is higher than that at PMMA-water interface, which is confirmed by the ratio of absolute values of molecular interaction parameters at these interfaces calculated on the basis of Rosen approach. If we take into account the hydration of the poly(ethylene oxide) chains of TX100 and acid and base parameters of the surface tension of water it appears that the PMMA surface is covered by the 'pure' water molecules from the solution or molecules connected with the chain of nonionic surfactant. On the other hand, the lack of SDS molecules at the PMMA-water interface may result from the formations of its micelles which are connected with the TX100 chain. (C) Koninklijke Brill NV, Leiden, 2011