The cohesive zone model approach is attractive for the analysis of failure of adhesively bonded structures. While the numerical implementation of cohesive elements has been well established, there remains a lack of cohesive material data. The present paper contributes to efforts to fill this void. An investigation of crack growth in the widely used structural adhesive Hysol EA-9394 is presented, and the adhesive is characterized by a cohesive zone law. Crack growth experiments were performed on specimens consisting of aluminum adherends bonded by use of the adhesive. Measurements of the surface topography leading reconstruction of fracture processes indicate that plastic deformation is absent during fracture. Thus, the cohesive zone law can directly be determined from the energy release rate and the material separation measured at the initial crack tip. The cohesive zone law is then applied in finite element model to predict crack growth. The predicted strain fields during crack growth are well matched to those obtained by digital image correlation measurements. An independent set of crack growth experiments was performed, and finite element models based on the cohesive law were used to predict the outcome of these experiments. Again good agreement between simulation and experiment was obtained. The results give confidence that the cohesive zone model parameters are transferable to the analysis of structures bonded with the adhesive Hysol EA-9394 in general. A comparison of the cohesive zone law for Hysol EA-9394 demonstrates that this adhesive possesses high strength and moderate toughness. Limits to the transferability regime are discussed. (C) Koninklijke Brill NV, Leiden, 2012