Many heavy oil reservoirs contain oil that has some limited mobility under reservoir conditions. In these reservoirs, a small fraction of the oil-in-place can be recovered using the internal reservoir energy through heavy oil solution gas drive (primary production). An integral part of this process is the so-called 'foamy oil mechanism', whereby oil is produced as a gas-in-oil dispersion. At the end of primary production, the bulk of the oil is still in place, while the natural energy of the reservoir has been depleted. This remaining oil is still mostly continuous and presents a valuable target for further recovery. Many of these reservoirs are relatively small or thin, or may be contacted by overlying gas or underlying water. As such, they are poor candidates for thermal oil recovery methods, so any additional oil recovery after primary production must be non-thermal. In this work, we present experimental results of foamy oil depletion at two different length scales and varying depletion rates. Tests were conducted in the absence of sand production, and the results from the depletion experiments are interpreted in terms of viscous forces. At the conclusion of primary recovery, the potential for further non-thermal exploitation of these reservoirs is explored. Results for waterflooding and chemical flooding are presented, demonstrating the viability of these techniques for heavy oil EOR. Several displacement mechanisms are identified through the secondary and tertiary processes that contribute to significant (although potentially slow) incremental recovery of heavy oil.