- Previous Article
- Next Article
- Table of Contents
Journal of Canadian Petroleum Technology, Vol.48, No.3, 57-65, 2009
Phase Behaviour and Physical Property Measurements for VAPEX Solvents: Part II. Propane, Carbon Dioxide and Athabasca Bitumen
The solubility of pure carbon dioxide in Athabasca bitumen was measured and compared with the literature data. Multiple liquid phases were observed at carbon dioxide contents above approximately 12 wt%. A correlation based on Henry's law was found to fit the saturation pressures at carbon dioxide contents below 12 wt%. The saturation pressure and solubility of carbon dioxide and propane in Athabasca bitumen, as well as the liquid phase densities and viscosities, were measured for three ternary mixtures at temperatures from 10 to 25 degrees C. Two liquid phases (carbon dioxide-rich and bitumen-rich) were observed at 13 wt% carbon dioxide and 19 wt% propane. Only liquid and vapour-liquid regions were observed for the other two mixtures (13.5 wt% propane and 11.0 wt% carbon dioxide; 24.0 wt% propane and 6.2 wt% carbon dioxide). The saturation pressures for the latter mixtures were predicted using the correlation for the carbon dioxide partial pressure and a previously developed correlation for the propane partial pressure. The mixture viscosities were predicted with the Lobe mixing rule.