Hydrous (or beta) oxide films produced on platinum in acid at room temperature usually give rise to two reduction peaks, in addition to the monolayer oxide response, on a negative sweep extending to about 0 V. This has been attributed to the presence of two hydrous oxide components (designated as HO1 and HO2) in the film. It was confirmed in the present work that under more severe conditions, 3.0M H2SO4 at 60 degrees C, an additional, quite significant, peak - apparently due to the presence of a further hydrous oxide component (HO3) - may be observed. The approximate peak maximum potential values (RHE scale) were 0.4 V (HO1), 0.2 V (HO2) and 0.0 V (HO3); the E(p) values are given here only as a guide : the processes involved occur under very irreversible conditions and the values vary with factors such as sweep rate, him thickness, temperature, etc. The differences in behaviour between these components is assumed to be due to factors such as the degree of aggregation and compactness in different regions of the gel-type, amorphous deposit. A brief account is given of the increasing evidence from different laboratories of unusual responses for platinum electrodes in aqueous acid solution.